Husqvarna 325HDA55 x-series, 325HE3, 325HE3 x-series, 325HE4 x-series manual Gear housing

Page 20

MAINTENANCE

Gear housing

There are three grease nipples on the gear housing. Use a grease gun to top up with grease. This should be carried out approximately every 20 working hours. Use Husqvarna special grease, part no. 503 98 96-01.

CAUTION! The gear housing must not be ﬁlled completely with grease. The grease expands as the machine heats up during operation. If the gear housing was completely ﬁlled with grease it could damage the seals and lead to leakage of grease.

The grease in the bevel gear does not normally need to be changed except if repairs are carried out.

Cleaning and lubrication

Clean any resin and plant residue from the blades using cleaning agent 531 00 60-75 (UL22) before and after using the machine.

Lubricate the blade bars with special grease, part no. 531 00 60-74 (UL 21) before long periods of storage

20 – English

Image 20

Contents 325HDA55X-series323HE3 KEY to Symbols SymbolsContents Introduction Dear CustomerWhat is WHAT? What is what?General Safety Precautions Personal protective equipmentMachine′s safety equipment Stop switchThrottle lock Hand guardVibration damping system MufﬂerGear housing BladesBlade guard 325HDA55Assembly Fuel Fuel safetyFuel Handling Fuelling MixingStarting and Stopping Check before startingStarting and stopping Cold engineStarting StoppingSafety instructions regarding the surroundings Safety instructions while workingWorking Techniques General working instructionsChanging the hedge trimmer angle Safety instructions after completing workBasic working techniques Maintenance CarburettorFine adjustment of the idle speed T Correctly adjusted carburettorMufﬂer High speed jet HCleaning the air ﬁlter Cooling systemSpark plug Air ﬁlterGear housing Cleaning and lubricationMaintenance schedule Maintenance Daily Weekly MonthlyTechnical Data Technical dataEC-declaration of conformity Applies to Europe only Cispr 121997, EN7741140333-26 ´z+HA@¶6¨ ´z+HA@¶6¨