Husqvarna 1153286-26 manual Warm engine, Starting, Stopping, Starter cord around your hand

Page 16

STARTING AND STOPPING

Warm engine

Ignition: Set the stop switch to the start position.

Choke: Put the choke in working position.

Primer bulb: Press the air purge repeatedly until fuel begins to ﬁll the bulb. The bulb need not be completely ﬁlled.

WARNING! When the engine is started

! with the choke in either the choke or start throttle positions the cutting attachment will start to rotate immediately.

Starting

Hold the body of the machine on the ground using your left hand (CAUTION! Not with your foot!). Grip the starter handle, slowly pull out the cord with your right hand until you feel some resistance (the starter pawls grip), now quickly and powerfully pull the cord. Never twist the

starter cord around your hand.

Reset the choke when the engine ﬁres, repeat pulling the cord until the engine starts.

CAUTION! Do not pull the starter cord all the way out and do not let go of the starter handle when the cord is fully extended. This can damage the machine.

Stopping

Stop the engine by switching off the ignition with the stop button.

16 – English

Image 16

Contents 324LDX-series KEY to Symbols SymbolsOperator of the machine must Ensure, while working, that no Persons or animals come closer thanContents Introduction Dear CustomerWhat is WHAT? What is what?General Safety Precautions Personal protective equipmentMachine′s safety equipment Throttle lockoutCutting attachment guard Stop switchVibration damping system Mufﬂer Locking nutCutting equipment Trimmer headAssembly Fitting the loop handleAssembling and dismantling the two-piece shaft Assembling the cutting equipmentFitting a trimmer guard and Superauto II 1 trimmer head Fitting other guards and cutting attachmentsFuel handling Fuel HandlingFuel Fuelling Starting and Stopping Check before startingStarting and stopping Cold engineWarm engine StartingStopping Starter cord around your handWorking Techniques Basic safety rulesGeneral working instructions Basic working techniques Grass trimming with a trimmer headCarburettor MaintenanceMufﬂer Cleaning the air ﬁlter Cooling systemSpark plug Two-piece shaftOiling the air ﬁlter Bevel gearMaintenance schedule Maintenance Daily Weekly MonthlyTechnical Data Technical dataApproved accessories Art No Use with Approved accessories TypeEC-declaration of conformity Applies to Europe only Super Auto Super Auto II Page S35 2,7mm 095-.106 25 m 15 cm T35, T35x Page Page Page Page Page Page Original instructions 1153286-26