Husqvarna 1153286-26 manual Assembly, Fitting the loop handle, Assembling the cutting equipment

Page 11

ASSEMBLY

Fitting the loop handle

•Clip the loop handle onto the shaft. Note that the loop handle must be fitted between the arrows on the shaft.

•Slide the spacer into the slot in the loop handle.

•Fit the nut, knob and screw. Do not overtighten.

•Now adjust the trimmer to give a comfortable working position. Tighten the bolt/knob.

Assembling and dismantling the two-piece shaft

Assembly:

•Loosen the coupling by turning the knob.

•Align the tab of the attachment (A) with the arrow on the coupling (B).

B

A

•Push the attachment into the coupling until the attachment snaps into place.

•Before using the unit, tighten the knob securely.

Dismantling:

•Loosen the coupling by turning the knob (at least 3 times).

•Push and hold the button (C). While securely holding the engine end, pull the attachment straight out of the coupling.

C

Assembling the cutting equipment

WARNING!

! When fitting the cutting attachment it is extremely important that the raised section on the drive disc/support flange engages correctly in the centre hole of the cutting attachment. If the cutting attachment is fitted incorrectly it can result in serious and/or fatal personal injury.

WARNING! Never use a cutting

! attachment without an approved guard. See the chapter on Technical data. If an incorrect or faulty guard is fitted this can cause serious personal injury.

English – 11

Page 10 Page 12
Image 11
Page 10 Page 12
Contents 324LDX-series Persons or animals come closer than KEY to SymbolsSymbols Operator of the machine must Ensure, while working, that noContents Dear Customer IntroductionWhat is what? What is WHAT?Personal protective equipment General Safety PrecautionsThrottle lockout Machine′s safety equipmentVibration damping system Stop switchCutting attachment guard Locking nut MufflerTrimmer head Cutting equipmentAssembling the cutting equipment AssemblyFitting the loop handle Assembling and dismantling the two-piece shaftFitting other guards and cutting attachments Fitting a trimmer guard and Superauto II 1 trimmer headFuel Fuel HandlingFuel handling Fuelling Cold engine Starting and StoppingCheck before starting Starting and stoppingStarter cord around your hand Warm engineStarting StoppingGeneral working instructions Basic safety rulesWorking Techniques Grass trimming with a trimmer head Basic working techniquesMuffler MaintenanceCarburettor Two-piece shaft Cleaning the air filterCooling system Spark plugBevel gear Oiling the air filterMaintenance Daily Weekly Monthly Maintenance scheduleTechnical data Technical DataEC-declaration of conformity Applies to Europe only Approved accessories TypeApproved accessories Art No Use with Super Auto Super Auto II Page S35 2,7mm 095-.106 25 m 15 cm T35, T35x Page Page Page Page Page Page Original instructions 1153286-26
Top Page Image Contents