CAUTION:
For tool with locking screw type wheel guard
•Before plugging in the tool, always check to see that the switch trigger actuates properly and returns to the "OFF" position when released.
•Switch can be locked in "ON" position for ease of operator comfort during extended use. Apply caution when locking tool in "ON" position and
maintain firm grasp on tool.
To start the tool, simply pull the switch trigger (in the B direction). Release the switch trigger to stop. For continuous operation, pull the switch trigger (in the B
1
2
3
006736
1.Wheel guard
2.Screw
3.Bearing box
direction) and then push in the lock lever (in the A direction). To stop the tool from the locked position, pull the switch trigger fully (in the B direction), then release it.
ASSEMBLY
CAUTION:
Mount the wheel guard with the protrusion on the wheel guard band aligned with the notch on the bearing box. Then rotate the wheel guard around 180 degrees counterclockwise. Be sure to tighten the screw securely. To remove wheel guard, follow the installation procedure in reverse.
For tool with clamp lever type wheel guard
•Always be sure that the tool is switched off and unplugged before carrying out any work on the tool.
Installing side grip (handle)
12
3
4
007049
1.Bearing box
2.Wheel guard
3.Nut
4.Lever
006735
CAUTION:
•Always be sure that the side grip is installed
securely before operation.
Screw the side grip securely on the position of the tool as shown in the figure.
Installing or removing wheel guard
CAUTION:
•When using a depressed center grinding
1. Nut
1
007050
Loosen the lever on the wheel guard. Mount the wheel guard with the protrusion on the wheel guard band aligned with the notch on the bearing box. Then rotate the wheel guard around to the position shown in the figure. Tighten the lever to fasten the wheel guard. If the lever is too tight or too loose to fasten the wheel guard, loosen or tighten the nut to adjust the tightening of the wheel guard band.
To remove wheel guard, follow the installation procedure in reverse.
5
