Replacing carbon brushes
ACCESSORIES
2
1
3
001146
1.Commutator
2.Insulating tip
3.Carbon brush
CAUTION:
• These accessories or attachments are recommended for use with your Makita tool specified in this manual. The use of any other accessories or attachments might present a risk of injury to persons. Only use accessory or attachment for its stated purpose.
• | Your tool is supplied with a guard for use with a |
When the resin insulating tip inside the carbon brush is exposed to contact the commutator, it will automatically shut off the motor. When this occurs, both carbon brushes should be replaced. Keep the carbon brushes clean and free to slip in the holders. Both carbon brushes should be replaced at the same time. Use only identical carbon brushes.
Use a screwdriver to remove the brush holder caps. Take out the worn carbon brushes, insert the new ones and secure the brush holder caps.
depressed center grinding wheel, |
wheel and wire wheel brush. If you decide to use |
your Makita grinder with approved accessories |
which you purchase from your Makita distributor or |
factory service center, be sure to obtain and use all |
necessary fasteners and guards as recommended in this manual. Your failure to do so could result in personal injury to you and others.
If you need any assistance for more details regarding these accessories, ask your local Makita Service Center.
1
006745
2
1.Brush holder cap
2.Screwdriver
To maintain product SAFETY and RELIABILITY, repairs, any other maintenance or adjustment should be performed by Makita Authorized or Factory Service Centers, always using Makita replacement parts.
8
