10Additional information
Problem | Remedy | ||
No sound is output or a noise | • Set the digital volume level of the player to full, or to the neutral | ||
is output when software with | position. | ||
DTS is played back. |
| ||
|
|
|
|
When a search is performed | • This is not a malfunction, but be sure to turn the volume down to | ||
by a DTS compatible CD | prevent the output of loud noise from your speakers. | ||
player during playback, noise |
| ||
is output. |
| ||
|
|
|
|
Can’t operate the remote | • Replace the batteries (refer to page 5). | ||
control. | • Operate within 7 m, 30° of the remote sensor on the front panel | ||
|
|
| (refer to page 6). |
|
|
| • Remove the obstacle or operate from another position. |
|
|
| • Avoid exposing the remote sensor on the front panel to direct light. |
|
|
|
|
The display is dark or off. | • Press FL DIMMER on the remote control repeatedly to return to | ||
|
|
| the default. |
|
|
|
|
|
|
|
|
|
|
|
|
•If the unit does not operate normally due to external effects such as static electricity disconnect the power plug from the outlet and insert again to return to normal operating conditions.
Resetting the main unit
Use this procedure to reset all the receiver’s settings to the factory default. Use the front panel controls to do this.
1Switch the receiver on.
2While holding down the TONE button,
press and hold the STANDBY/ON button for about three seconds.
3When you see RESET? appear in the display, press the TONE button.
OK? shows in the display.
4Press TONE once more to confirm. OK appears in the display to indicate that the receiver has been reset to the factory default settings.
Switching the speaker impedance
We recommend using speakers of 8Ω with this system, but it is possible to switch the impedance setting if you plan to use speakers with a 6Ω impedance rating.
•With the receiver in standby, press STANDBY/ON while holding down the SPEAKERS / SPEAKER IMPEDANCE button. Each time you do this, you switch between the impedance settings:
•SP 6 OHM – Use this setting if your speakers are rated at 6Ω.
•SP 8 OHM – Use this setting if your speakers are rated at 8Ω or more.
72
En
