Pioneer VSX-D714, VSX-D514 manual Controlling the rest of your system, VSX-D814only

Models: VSX-D714 VSX-D514

1 75
Download 75 pages 44.78 Kb
Page 61
Image 61
Controlling the rest of your system

Controlling the rest of your system

09

3Use the number buttons to enter the preset code.

You can find the preset codes on page 66 (VSX-D514/D714) and page 68 (VSX-D814).

The LED blinks again after you enter the code.

If the correct code has been input the power of the component being input will turn on or off.

The power of the component being input will only turn on or off if that component is able to be turned on directly by remote control.

You can only input a code for the compo- nent type written on each MULTI CONTROL button (except RECEIVER and TUNER).

Even if you don’t input a preset code for the TV (TV/SAT MULTI CONTROL button) you will be able to control your TV using the dedicated TV CONTROL on the remote if you have assigned it to the TV CONT button.

You may not be able to use a particular code even if it is listed on page 66.

The remote control buttons will not be able operate other equipment unless preset with the method above.

4Repeat steps 2 through 3 to try a different code, or to enter a code for another component you want to control.

5When you’re done, press RECEIVER.

Programming signals from other remote controls

VSX-D814 only

If the preset code for your component is not available, or the available preset codes do not operate correctly, you can program signals from the remote control of another compo-

nent (for example , , or other operation buttons). This can also be used to program additional operations (buttons not covered in the presets) after assigning a preset code.

1While pressing the RECEIVER button, press and hold the 2 button.

The LED blinks.

2Press the MULTI CONTROL button for the component you want to control.

The LED lights.

To exit or cancel press RECEIVER.

3Point the two remote controls towards each other about 2–5 cm apart then press the button that will be doing the learning on this receiver’s remote control.

The LED blinks rapidly.

2 – 5 cm

4Press the corresponding button on the other remote control that is sending (teaching) the signal to this receiver’s remote control.

If the operation has been learned success- fully, the LED on this receiver’s remote will blink once then light steadily.

If for some reason the operation hasn’t been learned the LED will blink for three seconds and then light steadily. If this happens, keep pressing the (teaching) button as you vary the distance between the two remotes, until you see the LED light steadily.

If there is not enough memory for this button to be learned by the remote, the LED will blink twice and the operation will be canceled.

5To program additional signals for the current component repeat steps 3 and 4. To program operations for another compo- nent exit and repeat steps 1 through 5.

Programming signals from other remote controlsEnglish Italiano Français Deutsch Nederlands Español

61

En

Page 61
Image 61
Pioneer VSX-D714 manual Controlling the rest of your system, Programming signals from other remote controls, VSX-D814only