Pioneer VSX-D714, VSX-D514 manual R C Ls Sw Sb Rs, L C R Rs Sw Ls Sb, Setting up the receiver

Setting up the receiver

5 Use and to adjust the delay for each channel in turn, pressing ENTER to go to the next channel when you’re done.

Listen to the reference channel and use it to measure the target channel. Stand facing the two speakers with your arms outstretched pointing at each speaker. Try to make the two tones sound as if they are arriving simulta- neously at a position slightly in front of you and between your arm span.

Setting separate channel levels for listening modes

• Default setting: 0 dB

You can set relative channel levels from the listening position using the method below (this is similar to the VSX-D714/D814 MCACC setup). Using CH SELECT (see tip below), it is also possible to set separate channel levels for each of the listening modes.

06

English Italiano

The test tone for channel delay is output in the same order as step 5:

R C LS

SW SB RS

After you have completed all the channels in your speaker setup, the volume level returns to normal and COMPLETE, then RESUME shows in the display.

The MCACC indicator then lights to show that MCACC setup is complete.

•Using the MCACC system to set up your speaker system will overwrite any previous settings you had for the STANDARD or ADVANCED SURROUND modes.

ADVANCED

STANDARD SURROUND

CH	LEVEL	TEST
SELECT		TONE

MASTER

VOLUME

1Press STANDARD or ADVANCED SURROUND.

2Press TEST TONE to output the test tone.

The test tone is output in the following order (depending on the speaker setting):

L C R RS

SW LS SB

•If you don’t hear a test tone from one of your speakers, please refer to Speaker setting on page 46 and (VSX-D714/D814 only) Surround back speaker setting on page 46 to make sure you have correctly specified your speaker setup.

Français Deutsch Nederlands Español

53

En