Additional information | 10 |
Problem | Remedy |
Considerable noise in radio | • Tune in the correct frequency. |
broadcasts. | • Connect the antenna (refer to page 19). |
| • Route any loose cables away from the antenna terminals and |
| wires. |
| • Fully extend the FM wire antenna, position for best reception, and |
| secure to a wall. |
| • Connect an outdoor FM antenna (refer to page 19). |
| • Adjust the direction and position for best reception. |
| • Connect an additional internal or external AM antenna (refer to |
| page 19). |
| • Turn off the equipment causing the noise or move it away from the |
| receiver. |
| • Move antennas farther away from equipment causing the noise. |
|
|
Broadcast stations cannot be | • Connect an outdoor antenna (refer to page 19). |
selected automatically. |
|
|
|
No sound from surround or | • Refer to Speaker setting on page 46 to check the speaker settings. |
center speakers. | • |
| area (MCACC) on page 52 to check the speaker levels. |
| • Connect the speakers properly (refer to page 20). |
English Italiano Français
No sound from surround back speakers
•Refer to Surround back speaker setting on page 46 to check the surround back speaker settings.
•Refer to Manually calibrating your listening area (MCACC) on page 52 to check the speaker levels.
•Refer to Using the Surround Back Channel (SB CH) on page 39 to make sure the SB CH MODE and the sound mode are set for surround back sound.
Deutsch
No sound from subwoofer. | • Make sure the subwoofer is switched on. |
| • If the subwoofer has a volume knob, make sure it’s turned up. |
| • Switch the Subwoofer setting on page 47 to YES or PLUS. |
| • Switch the LFE attenuator setting on page 47 to 0 dB or 10 dB. |
| • The Dolby Digital or DTS source you are listening to does not have |
| an LFE channel. |
|
|
Noise during playback of a | • Move the cassette deck further from your receiver, until the noise |
cassette deck. | disappears. |
|
|
Sound is produced from | • Set the SIGNAL SELECT to AUTO, DIGITAL or ANALOG |
other components, but not | according to the type of connections made. (refer to page 38). |
from LD or DVD player. | • Set the digital input settings correctly (refer to page 50). |
| • Make digital connections (refer to page 15) and set the SIGNAL |
| SELECT to DIGITAL (refer to page 38). |
| • Refer to the instruction manual supplied with the DVD player. |
|
|
Nederlands Español
71
En
