Pioneer VSX-D514 03Connecting up Using this receiver with a, Pioneer plasma display, VSX-D714/814

03Connecting up

Using this receiver with a

Pioneer plasma display

VSX-D714/D814 only

If you have a Pioneer plasma display (models PDP-504HDG and PDP-434HDG), you can use an SR+ cable (see note below) to connect it to this unit and take advantage of various convenient features, such as automatic video input switching of the plasma display when the input is changed.

•Use a 3-ringed miniplug SR+ cable to connect the CONTROL IN jack of this receiver with the CONTROL OUT of your plasma display.

Before you can use the extra SR+ features, you need to make a few settings in the receiver. See Using the SR+ mode with a Pioneer plasma display on page 54 for detailed instructions.

CONTROL

OUT

VIDEO	Pioneer plasma	VIDEO
INPUT 3		INPUT 1
	display
Pioneer plasma
display
Media receiver
DVD player	Satellite receiver, etc

								CEN-	SUB WOOFER	DVD	TV/SAT
								TER
		IN		AUX
DIGITAL OUT					FM UNBAL	AM				AUDIO IN	AUDIO IN
		IN		CD	75 Ω	LOOP	A N TE NN A		L
	OPT						R
						OUT	MONITOR OUT
								SURROUND
	OPT	OUT		DVR/		CONTROL		DVD 5.1CH INPUT
	2			VCR		IN
( D V R / V C R )		IN			VIDEO		OUT
	OPT						DVR/	S	R
	1			TV /	IN	OUT	VCR
	(TV /			SAT			IN	P
ASSIGNABLE	SAT) IN				IN
	COAX			DVD				E
DIGITAL IN						MONITOR	T V /
	2			/LD							VSX-D714/814
		IN		FRONT		OUT	SAT	A
	(CD)				5.1CH		IN		A
					D V D	SUB		K
	COAX			REC	INPUT		D VD
	1				IN	WOOFER		E
	(DVD	OUT		CD-R		PREOUT	/LD
	/LD)			/ TAPE			IN	R
				/ MD			S-VIDEO			To make the most of the SR+ features, you
		R	AUDIO	L				S
		IN		PLAY
										should connect your source components
* The illustration shows the VSX-D814, but										(DVD player, etc.) in a slightly different way to
										that described in this chapter. For each
connections for the VSX-D714 are the same.										component, connect the video output directly
										to the plasma display, and just connect the
										audio (analog and/or digital) to this receiver.

•If you connect to a Pioneer plasma display using an SR+ cable, you will need to point the remote control at the plasma display remote sensor to control the receiver. In this case, you won’t be able to control the receiver using the remote control if you switch the plasma display off.

26

•The 3-ringed miniplug SR+ cable from Pioneer is commercially available under the part number ADE7095. Contact the Pioneer Customer Support division for more infor- mation on obtaining an SR+ cable.

En