Pioneer VSX-D714 manual Connecting the speakers VSX-D514/D714, 03Connecting up, R Front L

03Connecting up

Connecting the speakers (VSX-D514/D714)

A complete setup of six speakers (including the subwoofer) is shown below, but everyone’s home setup will vary. Simply connect the speakers you have in the manner shown below. The receiver will work with just two stereo speakers (the front speakers in the diagram) but using at least three speakers is recommended, and a complete setup is best. If you’re not using a subwoofer, change the front speaker setting (see Speaker setting on page 46) to large.

Make sure you connect the speaker on the right to the right terminal and the speaker on the left to the left terminal. Also make sure the positive and negative (+/–) terminals on the receiver match those on the speakers. You can use speakers with a nominal impedance between 6–16Ω(please see Switching the speaker impedance on page 72 if you plan to use speakers with an impedance of less than 8Ω).

Be sure to complete all connections before connecting this unit to the AC power source.

Front speakers		Center speaker		Surround speakers
L	R		C	LS	RS

		IN		AUX
DIGITAL OUT					FM UNBAL	AM
		IN		CD	75 Ω	LOOP	ANTENNA
	OPT						MONITOR	OUT
						OUT
		OUT		DVR/		CONTROL
				VCR		IN
DIGITAL IN	OPT	IN			VIDEO			OUT
								DVR/
	1			TV /	IN	OUT		VCR
	(TV /	IN		SAT				IN
	SAT)				IN
ASSIGNABLE	COAX			DVD		MONITOR		TV/
	2			/LD
		IN		FRONT		OUT		SAT
	(CD)							IN
					D V D
	COAX			REC	5.1CH	SUB
					INPUT	WOOFER		DVD
	1			CD-R	IN
	(DVD	OUT				PREOUT		/LD
				/ TAPE				IN
	/LD)			/ MD		SURROUND	S-VIDEO
						BACK
		IN		PLAY
		R	AUDIO	L

TERCEN-	SUB WOOFER
			COMPONENT VIDEO		ASSIGNABLE
					( DVD / LD) IN ¥
R	L	MONITOR OUT
SURROUND
DVD 5.1CH INPUT
	Y	PB	PR	Y	PB	PR
					(T V / SAT) IN ø
S	R FRONT	L	CENTER			R SURROUND L
P
E
A	A
K
E
R
S

R FRONT L

B

VSX-D714

Powered subwoofer

SW

INPUT

* The illustration shows the VSX-D714, but connections for the VSX-D514 are the same.

20

En