Troy-Bilt 52063, 52064 owner manual Assembly, Connect and Charge Battery

Page 8

6Section 2: Assembly

STEP 6: Connect and Charge Battery

DANGER

•Wet conditions can cause an electric shock hazard during battery recharging. Avoid wet conditions when charging battery.

•Recharging the battery with improper equipment could cause a battery explosion. Use only the battery charger shipped with the unit. The engine must be shut off and the spark plug wire disconnected and moved away from the spark plug.

Failure to comply could result in per- sonal injury or property damage.

1. Lift and tilt debris shield (X, Figure 2-

5)forward to view battery (P). Connect the red wire (R, Figure 2-6) to the posi- tive (+) red-coded terminal on the bat- tery. Then, connect the black wire (S) to the negative (–) black-coded terminal on the battery. Close the debris shield (X, Figure 2-5).

2. Connect the small receptacle (U, Figure 2-7) on the battery recharger cord to the wire harness plug (V) located near the keyswitch. Then, plug the charger box (W) into a grounded, 120V wall outlet.

3. Charge the battery for 24 hours. After charging, first unplug the charger box (W) from the wall outlet, then dis- connect the recharging line plugs (U and V).

X

P

Figure 2-5: Lift and tilt debris shield forward to access battery.

R

S

Figure 2-6

W

V U

Figure 2-7

Page 7 Page 9
Image 8
Page 7 Page 9
Contents Trimmer/Mower See Back Cover for Customer Service information Safety General OperationService SafetySlope Operation ChildrenSafety Decals Never make adjustments or repairs while engine is runningNever run the engine inside a closed area On engine, above mufflerAssembly Assembly StepsInstall Handlebars IntroductionCheck Trimmer Head Hardware Attach Throttle Control LeverAdd Motor Oil Lift and tilt debris shield X, Figure AssemblyConnect and Charge Battery Features and Controls Features and ControlsOperating Symbols PRE-START Checklist Adjust Handlebar HeightAdjust Line Cutting Height OperationOperation Operating the MachineAdditional Operating Tips and Techniques Vary Throttle Setting For Conditions Trim When Wet or DryClean the Unit Frequently Trimming/Mowing Quick Reference ChartRequired Maintenance MaintenanceAdjusting Trimmer Head Engagement Maintenance Belt InspectionBelt Removal Removing and Replacing the Trimmer HeadBelt Replacement KR TCleaning the Engine General Engine MaintenanceTRIMMER/MOWER Cleaning and Debris Removal LubricationBattery Service Battery RechargingBattery Replacement OFF-SEASON StorageChanging Trimmer Lines To Change Trimmer LinesTroubleshooting Problem Possible Cause CorrectionParts List Drawing noRef. # Ref. # Description QtyParts List Drawing no Ref. # DescriptionDrawing no Parts List Drawing no Accessories and KitsWarranty Service Replacement PartsEngine Service and Repair Owner Registration Card
Top Page Image Contents