Troy-Bilt TB2000 manual Holding the Trimmer, Adjusting Trimming Line Length

Page 12

Operation (continued)

Fig. 5-4

HOLDING THE TRIMMER

Always wear eye, hearing, foot and body protec- tion to reduce the risk of injury when operating this unit.

Before operating the unit, stand in the operating posi- tion (Fig. 5-4). Check for the following:

The operator is wearing eye protection and proper clothing.

The right arm is slightly bent, and the hand is hold- ing the shaft grip.

The left arm is straight, and the hand is holding the D-handle.

The unit is at waist level.

The cutting attachment is parallel to the ground and easily contacts the vegetation to be cut without the operator having to bend over.

ADJUSTING TRIMMING LINE LENGTH

The AFS™ cutting attachment (Automatic Feed System) automatically feeds out cutting line as needed. A blade on the cutting attachment shield will cut the line to the proper length if excess line is released.

NOTE: If the lines stops feeding, this is usually a sign that the cutting attachment requires new line. See Section 6, Maintenace, Line Installation.

NOTE: Do not rest the AFS cutting attachment on the ground while the unit is running .

Do not remove or alter the line cutting blade assembly. Excessive line length will make the clutch overheat. This may lead to serious person- al injury or damage to the unit.

Some line breakage will occur from:

Entanglement with foreign matter

Normal line fatigue

Attempting to cut thick, stalky weeds

Forcing the line into objects such as walls or fence posts

TIPS FOR BEST TRIMMING RESULTS

Keep the cutting attachment parallel to the ground.

Do not force the cutting attachment. Allow the tip of the line to do the cutting, especially along walls. Cutting with more than the tip will reduce cutting efficiency and may overload the engine.

Cut grass over 8 inches (200 mm) by working from top to bottom in small increments to avoid prema- ture line wear or engine drag.

Cut from left to right whenever possible. Cutting to the right improves the unit's cutting efficiency. Clippings are thrown away from the operator.

Slowly move the trimmer into and out of the cutting area at the desired height. Move either in a for- ward-backward or side-to-side motion. Cutting shorter lengths produces the best results.

Trim only when grass and weeds are dry.

The life of your cutting line is dependent upon;

Following the previous trimming techniques

What vegetation is being cut

Where it’s being cut

For example, the line will wear faster when trimming against a foundation wall as opposed to trimming around a tree.

12

Image 12
Contents Owner/Operator Manual Cycle Trimmer Table of Contents IntroductionService Information Accessory 181696 Spark Arrestor KitSafety Symbol MeaningSafety Warnings for GAS Trimmers Before OperatingOther Safety Warnings While OperatingOperation Safety and International Symbols Symbol Meaning Safety Alert SymbolFor Service INFORMATION, Call Unleaded FuelSymbol Meaning ON/OFF Stop Control HOT Surface WarningSharp Blade Choke Control Do not USE BladesKnow Your Unit ApplicationsAssembly Installing and Adjusting the D-HANDLEInstalling the Cutting Attachment Shield Using Blended Fuels Using Fuel AdditivesOil and Fuel Definition of Blended FuelsOperation Starting InstructionsStopping Instructions Adjusting Trimming Line Length Holding the TrimmerTips for Best Trimming Results Maintenance Schedule When Maintenance Needed GO toDecorative Trimming Line Installation Go To for Membrane Line InstallationWinding the Existing Inner Reel Installing a Prewound Reel Pawl ReplacementReplacement Parts See Accessories / Replacement Parts on AIR Filter Maintenance Carburetor AdjustmentCleaning the Air Filter Clean Air FilterReplacing the Spark Plug ACCESSORIES/REPLACEMENT Parts CleaningStorage Long Term StorageU S E T I O NU S EA C T I O N U S E T I O NSpecifications EnginePage MTD Southwest Inc