Troy-Bilt TB2000 manual Installing a Prewound Reel, Pawl Replacement

Page 15

Maintenance (continued)

Slotted

Hole

Fig. 6-4

Fig. 6-5

Holding

Slot

Holding

Slot

Fig. 6-6

Eyelet

Eyelet

Fig. 6-7

12.Insert the ends of the line into the two holding slots (Fig. 6-6). Leave about 4 inches (102 mm) of line beyond the holding slots.

13.Insert the ends of the line through the eyelets in the outer spool and place inner reel inside the outer spool (Fig. 6-7).

14.While holding the inner reel and outer spool, grasp the ends and pull firmly to release the line from the holding slots in the inner reel.

15.Push the bottom cover into the outer spool until it snaps into place

INSTALLING A PREWOUND REEL

1.Press the tabs in and remove the bottom cover (Fig. 6-1).

2.Remove the old inner reel from the outer spool (Fig. 6-1).

3.Take the prewound inner reel and Insert the ends of the line through the eyelets in the outer spool (Fig. 6-7).

4.While holding the inner reel and outer spool, grasp the ends and pull firmly to release the line from the holding slots in the inner reel.

5.Push the bottom cover into the outer spool until it snaps into place

Replacement Parts:

See Accessories / Replacement Parts on page 18.

PAWL REPLACEMENT

If the pawl in the cutting attachment requires replace- ment due to cracking or wear, use the following instructions.

1.Position the pawl so that it is hooked by the spring (Fig. 6-8).

2.Position a medium sized flat bladed screwdriver through the tab hole in the outer spool and under the pawl as shown in figure 6-8. The end of the screw- driver needs to be right next to the pawl shaft.

3.Turn the screwdriver to remove the pawl from it’s retaining hole in the outer spool.

4.Replace with a new pawl. Press the pawl in firmly until it snaps into place.

Position Pawl

Pawl Shaft

Tab Hole

 

Fig. 6-8

Screwdriver

 

15

Image 15
Contents Owner/Operator Manual Cycle Trimmer Introduction Table of ContentsAccessory 181696 Spark Arrestor Kit Service InformationBefore Operating SafetySymbol Meaning Safety Warnings for GAS TrimmersOther Safety Warnings While OperatingOperation Unleaded Fuel Safety and International SymbolsSymbol Meaning Safety Alert Symbol For Service INFORMATION, CallDo not USE Blades Symbol Meaning ON/OFF Stop ControlHOT Surface Warning Sharp Blade Choke ControlApplications Know Your UnitAssembly Installing and Adjusting the D-HANDLEInstalling the Cutting Attachment Shield Definition of Blended Fuels Using Blended FuelsUsing Fuel Additives Oil and FuelOperation Starting InstructionsStopping Instructions Adjusting Trimming Line Length Holding the TrimmerTips for Best Trimming Results Maintenance Schedule When Maintenance Needed GO toDecorative Trimming Line Installation Go To for Membrane Line InstallationWinding the Existing Inner Reel Installing a Prewound Reel Pawl ReplacementReplacement Parts See Accessories / Replacement Parts on Clean Air Filter AIR Filter MaintenanceCarburetor Adjustment Cleaning the Air FilterReplacing the Spark Plug Long Term Storage ACCESSORIES/REPLACEMENT PartsCleaning StorageU S E T I O N U S ET I O N U S EA C T I O NEngine SpecificationsPage MTD Southwest Inc