Ryobi PLT3043S manual Assembly Instructions, Grass Deflector, Bolt, Bracket Lock Washer, Wing Nut

Page 8

ASSEMBLY INSTRUCTIONS:

ASSEMBLY

ASSEMBLY INSTRUCTIONS:

GRASS DEFLECTOR

See Figure 4.

1.Remove wing nut, flat washer, lock washer, and bolt from the Owner’s Kit.

2.Place grass deflector over shaft and bracket.

3.Install bolt through the slots in the tabs on grass deflector and bracket on driveshaft housing.

4.Install flat washer, lock washer and wing nut.

5.Tighten Securely.

BOLT	GRASS
	DEFLECTOR

BRACKET

LOCK WASHER

FLAT
WASHER	WING NUT	Fig. 4
	WING NUT

FRONT HANDLE

See Figure 5.

1.Place the handle base and the bracket on the driveshaft housing below the spacer.

2.Install the two handle base screws and nuts, but do not tighten completely.

3.Place the handle grip onto the handle base and install the two screws. Tighten securely.

4.Adjust the position of the handle for best balance and comfort.

5.Tighten the two handle base screws securely.

NOTE: Do not attempt to remove or modify the spacer. This spacer limits the upper position of the handle grip. See

Figure 5.

HANDLE BASE

SCREWS

HANDLE

BASE

BRACKET

NUTS

SPACER

HANDLE GRIP

SCREWS

Fig. 5

Image 8

Contents OPERATORS MANUAL String Trimmer PLT3043S SAVE THIS MANUAL FOR FUTURE REFERENCETABLE OF CONTENTS SAFETYGENERAL SAFETY RULES READ ALL INSTRUCTIONSSPECIFIC SAFETY RULES FOR TRIMMER USE SYMBOLS SYMBOLNAME EXPLANATIONSAVE THESE INSTRUCTIONS TECHNICAL DATASYMBOL MEANING FEATURES ENGINE HOUSING THROTTLE INTERLOCK IGNITION SWITCHUNPACKING INSTRUCTIONSASSEMBLY REMOVING THE ATTACHMENT FROM THE POWER HEADATTACHING THE STORAGE HANGER See FigureASSEMBLY INSTRUCTIONS GRASS DEFLECTORBOLT BRACKET LOCK WASHERBENT END OF MUFFLER GUARD OPENING IN REAR HOUSING MUFFLER GUARD ASSEMBLYREAR HOUSING TORX WRENCH SCREWS MUFFLER GUARD OPERATION FUEL AND REFUELINGOPERATING THE TRIMMER HANDLING THE FUEL SAFELYADVANCING THE STRING CUTTING TIPSGRASS DEFLECTOR LINE TRIMMING CUT- OFF BLADE ADVANCING THE STRING MANUALLYIGNITION SWITCH STARTING AND STOPPINGSee Figures 10 and TO START A COLD ENGINEMAINTENANCE SPOOL REPLACEMENT EZ LINE TAP ADVANCE SYSTEMNEW PREWOUND SPOOL See Figures 12 andCLEANING THE EXHAUST PORT AND MUFFLER STRING REPLACEMENTCleaning Instructions SPARK ARRESTORREPLACING AND CLEANING AIR FILTER FUEL CAPSPARK PLUG TRANSPORTINGTROUBLESHOOTING SAFETY DIRECTIVE SOUND POWERIDLE SPEED SCREW “L” LO NEEDLE SOUND PRESSUREGUARANTEE WARRANTYGUARANTEE - STATEMENT RTSA / RTUK / RTG Page Ryobi Technologies GmbH Ryobi TechnologiesRyobi Technologies Ryobi Technologies Australia PTY Limited