Ryobi PLT3043S Muffler Guard Assembly, Rear Housing Torx Wrench Screws Muffler Guard, See Figure

Page 9

ASSEMBLY

MUFFLER GUARD ASSEMBLY

See Figure 6.

1.Remove muffler guard and two screws from the owner's kit.

2.Attach the muffler guard to the rear housing.

NOTE: Make sure the bent end of the muffler guard fits securely into the opening of the rear housing.

3.Using the torx wrench supplied, install the two screws and tighten securely.

TORX

WRENCH

SCREWS MUFFLER

GUARD

MUFFLER GUARD

OPENING IN REAR

HOUSING

Fig. 6

Image 9

Contents SAVE THIS MANUAL FOR FUTURE REFERENCE OPERATORS MANUAL String Trimmer PLT3043SSAFETY TABLE OF CONTENTSGENERAL SAFETY RULES READ ALL INSTRUCTIONSSPECIFIC SAFETY RULES FOR TRIMMER USE SYMBOL SYMBOLSNAME EXPLANATIONTECHNICAL DATA SYMBOL MEANINGSAVE THESE INSTRUCTIONS ENGINE HOUSING THROTTLE INTERLOCK IGNITION SWITCH FEATURESUNPACKING INSTRUCTIONSREMOVING THE ATTACHMENT FROM THE POWER HEAD ASSEMBLYATTACHING THE STORAGE HANGER See FigureGRASS DEFLECTOR ASSEMBLY INSTRUCTIONSBOLT BRACKET LOCK WASHERMUFFLER GUARD ASSEMBLY REAR HOUSING TORX WRENCH SCREWS MUFFLER GUARDBENT END OF MUFFLER GUARD OPENING IN REAR HOUSING FUEL AND REFUELING OPERATIONOPERATING THE TRIMMER HANDLING THE FUEL SAFELYCUTTING TIPS ADVANCING THE STRINGGRASS DEFLECTOR LINE TRIMMING CUT- OFF BLADE ADVANCING THE STRING MANUALLYSTARTING AND STOPPING IGNITION SWITCHSee Figures 10 and TO START A COLD ENGINESPOOL REPLACEMENT EZ LINE TAP ADVANCE SYSTEM MAINTENANCENEW PREWOUND SPOOL See Figures 12 andSTRING REPLACEMENT CLEANING THE EXHAUST PORT AND MUFFLERCleaning Instructions SPARK ARRESTORFUEL CAP REPLACING AND CLEANING AIR FILTERSPARK PLUG TRANSPORTINGTROUBLESHOOTING SOUND POWER SAFETY DIRECTIVEIDLE SPEED SCREW “L” LO NEEDLE SOUND PRESSUREWARRANTY GUARANTEE - STATEMENT RTSA / RTUK / RTGGUARANTEE Page Ryobi Technologies Ryobi Technologies GmbHRyobi Technologies Ryobi Technologies Australia PTY Limited