RULES FOR SAFE OPERATION
SAFETY WARNINGS FOR
BATTERY TRIMMERS
•Battery tools do not have to be plugged into an electrical outlet; therefore, they are always in operating condition. Be aware of possible hazards, such as cutting attachment, even when tool is not operating.
•Use only the charging stand provided with your unit. Do not substitute any other charging stand. Use of another charging stand could promote batteries to explode causing possible serious injury.
•Do not place battery units or their batteries near fire or heat. They may explode causing serious personal injury and damage to unit.
•Do not charge unit in a damp or wet location.
•Your unit should be charged in a location where the temperature is more than 50˚F (10˚C) but less than 100˚F (38˚C).
•Do not disassemble the battery housing. Battery should be recycled, consult your local waste authority for information regarding available recycling and/or disposal options.
SAFETY WARNINGS FOR
CHARGING STANDS
•Before using charging stand, read all instructions and cautionary markings in this manual, on charging stand, and product using charging stand.
•Do not expose charger to rain or snow.
•To reduce risk of injury, charge only sealed
•To reduce risk of damage to charger body and cord, pull by the charger body, rather than cord, when disconnecting the charger.
•Make sure charger cord is located so that it will not be stepped on, tripped over, or otherwise subjected to damage or stress.
•Do not operate charger with a damaged cord or plug. If damaged, replaced charger immediately.
•Do not operate charger if it has received a sharp blow, been dropped, or otherwise damaged in any way. If the charger case is damaged, replace the charger.
•Do not disassemble charger. The charger is not serviceable; disassembly may result in a risk of electric shock or fire.
•To reduce risk of electric shock, unplug the charger from outlet before attempting any maintenance or cleaning.
•Do not use charger outdoors.
WHILE OPERATING
•To avoid accidental starting, never carry your trimmer with your finger on the trigger.
•Wear safety glasses or goggles that are marked as meeting ANSI
•Wear heavy, long pants, boots and gloves. Do not wear loose clothing, jewelry, short pants, sandals or go barefoot. Secure hair above shoulder level.
•The cutting attachment shield must always be in place while operating the unit. Do not operate unit without trimming line extended, and the proper line installed. Do not extend the trimming line beyond the length of the shield.
•Adjust the handle to your size to provide the best grip.
•Be sure the cutting attachment is not in contact with anything before starting the unit.
•Use the unit only in daylight or good artificial light.
•Use the right tool. Only use this tool for the purpose intended.
•Do not overreach. Always keep proper footing and balance.
•Do not force the unit. It will do the job better and with less likelihood of a risk of injury at the rate for which it was designed.
•Always hold the unit with both hands when operating. Keep a firm grip on both the battery housing grip and D- handle.
•Keep hands, face, and feet at a distance from all moving parts. Do not touch or try to stop the cutting attachment when it is rotating.
•Always stop the motor when cutting is delayed or when walking from one cutting location to another.
•If you strike or become entangled with a foreign object, stop the unit immediately and check for damage. Do not operate before repairing damage. Do not operate the unit with loose or damaged parts.
•Release the trigger, ensure the
•Keep unit clean of vegetation and other materials. They may become lodged between the cutting attachment and shield.
4