Assembly Instructions, Mounting the Charging Station

ASSEMBLY INSTRUCTIONS

This unit is completely assembled. However, some adjustments may be required to provide safe and easy use for the operator.

It is suggested that you mount the charging unit per instructions and allow the unit to charge for at least 36 hours prior to first use.

MOUNTING THE CHARGING STATION

Since this unit may stay on the charging station continuously without overcharging, it is suggested that the charging station be in a place where the unit is intended to be stored. This should be a place that is cool, dry and well ventilated, where the unit can be locked-up and out of the reach of children.

Your unit should be charged and stored in a location where the temperature is more than 50˚F (10˚C) but less than 100˚F (38˚C).

1.Locate a place for the charging station near a wall outlet and high enough to keep the unit off the floor.

2.Locate the wall stud and mount the charging station to the wall using the three (3) screws provided (Fig 1). Make sure that the screws enter the wall stud to provide a secure mount.

CAUTION: To prevent injury or damage to the unit, the charging station must be mounted securely to the wall.

3.Plug the charger into the wall outlet and wrap any excess wire onto the cord wrap on the charging station (Fig. 1).

Screw

Charging

Station

Wall

Outlet

Charger

Cord

Wrap

Wall Stud

Fig. 1

INSTALLING AND ADJUSTING THE D-HANDLE

1.Push the D-handle down onto the shaft housing so that the handle slants to the powerhead (Fig. 2). The squared bolt hole in the handle is to the right.

2.Insert the shoulder bolt and washer into the squared hole in the handle. Screw the wing nut onto the bolt.

3.Rotate the D-handle to place the grip above the top of the shaft housing.

4.While holding the unit in the operating position (Fig. 3), position the D-handle to the location that provides you the best grip, and tighten the wing nut (Fig. 4).

Wing

Nut

BoltWasher

Fig. 2

Fig. 3

Grip

Fig. 4