Echo 2601, 261, 231, SRM-2100SB, 2400, 260SB, 225VP, 230 Gear Housing Assembly, Drive Shaft Assembly

1.Brush loose debris from blade and coat both sides of blade with the 50-50 cleaning mixture.

2.Allow cleaning mixture to soften the remaining gummy residue then wipe it from the blade.

3.Apply clean oil to the entire length of the blade. Be certain the blade bolts are lubricated.

4.Wipe excess oil from the blade before putting the unit back in service.

Gear Housing Assembly

Level 1.

Parts Required: POWER BLENDXTM 14 oz. or Lithium Base Grease.

1.Clean dirt from the grease fitting (A).

2.Carefully pump grease into fitting (A). DO NOT force grease. Too much pressure will force grease past seals and cause damage. Apply 1-2 pumps of grease every 15-25 hours of operation.

3.Wipe excess grease from around grease fitting.

Drive Shaft Assembly

Level 1.

Parts Required: POWER BLENDXTM 8 oz. or Lithium Base Grease.

A

1.Remove gear housing locating screw (A) and loosen clamping screw (B). Remove the gear housing assembly from the drive shaft housing..

2.Pull the drive shaft (C) from the housing, wipe clean and re-coat with a thin coating [1/2 oz. (15 ml)] of grease.

3.Slide the drive shaft back in the drive housing being careful not to get dirt on the flex shaft.

A

C

B