Echo 99944200615 manual Lubrication, Nylon line replacement

Page 11

PAS Rapid LoaderTM Curved Shaft Trimmer Attachment 11 Operator's Manual

lubrication

Level 1.

Parts Required: POWER BLENDXTM 8 oz. (P/N 91014) or Lithium Base Grease.

1.Remove plastic shield.

2.Loosen bearing housing locating screw (A), at the top of the hous- ing, loosen mounting screw (B) and remove gear case from drive housing.

3.Pull the flexible drive shaft (C) from the drive housing, wipe clean and recoat with a thin coating [1/2 oz. (15 ml)] of grease.

4.Slide the flexible drive shaft back in the drive housing being care- ful not to get dirt on the flexible drive shaft.

5.Install the bearing housing and shield.

B

A

C

nylon line replacement

Level 1.

Parts Required: Pre-cut Nylon Line

1.Shut engine off. Lay unit on the ground with head assembly up.

2.Remove old nylon line through center recess of head.

3.Insert pre-cut 204 mm (8 in.) length of nylon cutting line (recom- mended sizes 2.4 mm [.095 in.] to 3.9 mm [.155 in.]) through outside openings of trimmer head. Minimum of 153mm (6 in.) of line should extend from each opening. 3.9mm [.155 in.] line not recommended for trimmers under 26cc.

NOTE

Insert cutting line ends to center of head recess to insure easy removal of used lines.

Notice:

Nylon line can damage plastic shield. When installing line seg- ments, make sure line does not curve upward toward shield.

MODELS

REQUIRED LINE SIZES

SRM-2100SB

 

SRM-210SB/211SB

 

PAS-210/211

.080 - .095 in.

PAS-225

 

PAS-230/231

 

SRM-2400SB

.095 - .130 in.

 

 

 

SRM-260SB/261SB

.095 - .155 in.

PAS-2601

PAS-260/261

 

PAS-265

 

 

 

 

 

 

 

Image 11
Contents PAS Rapid LoaderTM Curved Shaft Grass Trimmer Attachment Operators manual Safety manualTable of Contents IntroductionInternational symbols Safety Manual safety symbols and important informationPhysical Condition Personal condition and safety equipmentRepetitive Stress Injuries Description EquipmentContents Nylon line head installation/removal AssemblyPlastic shield installation Power head shaft/attachment lower shaft assembly Skill levels MaintenanceMaintenance intervals OperationLubrication Nylon line replacementStorage SpecificationsPage Page Page Echo consumer product support ServiceWarranty registration Additional or replacement manuals Servicing Information parts/serial number