Echo SHC-265 manual Contents, Assembly, Drive shaft/power head

Page 9

Shaft Hedge Clipper

9

Operator's Manual

Contents

The ECHO product you have purchased has been factory pre-assembled for your convenience. Due to packaging restric- tions, some assembly of the SHC-260 is required.

After opening the carton, check for damage. Immediately notify your retailer or ECHO Dealer of damaged or missing parts. Use the contents list to check for missing parts.

___ 1 - Power Head

___ 1 - Gear Case Assembly

___ 1 - Drive Shaft Assembly

___ 1 - Operator's Manual

___ 1 - Hedge Clipper Safety Manual

___ 1 - Warranty Registration Card

___ 1 - Blade Cover

___ 1 - 4 mm Hex Wrench

Assembly

Tools Required: 4 mm Hex Wrench

Parts Required: Power Head, Drive Shaft Assembly, and Gear Housing Assembly.

drive shaft/power head

1.Stand power head upright on a level surface.

2.Loosen the two (2) drive shaft clamp bolts (B) at engine drive shaft clamp, and remove center drive shaft location bolt (A).

3.Carefully fit driveshaft assembly to engine making sure that inner drive shaft engages clutch mount.

4.Turn drive shaft housing until locating hole lines up with location hole in clamp and install center drive shaft location bolt (A).

BB

A

Page 8 Page 10
Image 9
Page 8 Page 10
Contents
Shaft Hedge Clipper Table of Contents Safety manualIntroduction Operators manualInternational symbols Safety Manual Safety Symbols and Important InformationProper Clothing Physical ConditionEye Protection Hand Protection Repetitive Stress Injuries EPA 2010 and Later and/or C.A.R.B. Tier EquipmentEmission Control exhaust & evaporative Description Hot Decal near muffler DriveshaftSupport Handle for Left Hand Cushioned grip for Left Hand Throttle Handle for Right Hand Cushioned grip for right handContents AssemblyDrive shaft/power head Throttle linkage and ignition leads Gear housing assembly / drive shaft OperationFuel Handling Fuel Fuel RequirementsAfter use Shaft Hedge Clipper 13 Operators ManualPurge Bulb Starting cold engineStarting warm engine Shaft Hedge Clipper Operators ManualHedge trimming Stopping engineMaintenance Maintenance intervalsSkill levels Air filter Fuel filterLevel Cooling system Spark plugExhaust system Spark Arrestor ScreenExhaust Port Cleaning Carburetor adjustment Engine Break-InHigh Altitude Operation Gear Housing Assembly BladesLubrication Drive Shaft Assembly Sharpening blades Blade adjustmentInternal engine problem See your Echo dealer TroubleshootingStorage Long Term Storage over 30 daysModel SHC-265 SpecificationsExceptions Warranty Statements99922201032 12/03/09 01/2010 Warranty registration Additional or replacement manuals ServiceServicing Information parts/serial number Echo consumer product support
Top Page Image Contents