REPLACINGTHELINE
1.Removethespoolbyfirmlypulling onthetapbutton.
2.Cleanentire surface of hub and spool.
3.Replace with a
feet of 0.065" (1.65 mm) diameter Craftsman (_)Pro Trimmer line. Use
of heavier lines could overload the unit and damage unit.
,_WARNING: | Never use wire, |
rope, string, etc., which can break off and become a dangerous missile.
4.Insert one end of the line about 1/2 inch (1 cm) into the small hole in- side the spool.
5.Wind the line evenly and tightly
onto the spool. Wind in the direc- tion of the arrow found on the
spool.
6.Push the line into the notch, leav-
ing 3 to 5 inches (7 - 12 cm) un- wound.
7.Insert the line into the exit hole in
USER REPLACEABLE SERVICE PARTS
the hub as shown in the illustra- tion.
8.Align the notch with the line exit hole.
9.Push the spool into the hub until it snaps into place.
10.Pull on the line extending outside the hub to release it from the
notch; otherwise, the unit will not function properly.
Small |
|
|
Hoie__ 4_ / _/_, | "i |
|
,_ d" | ||
Button |
|
|
Line in Notch | _ | // |
Hub
Line exit hole
REPLACEMENT PART
Spool with 0.065" Pro Trimmer Line Assist Handle
Bolt, Assist Handle,
Wing Nut, Assist Handle
Shield Assembly
Edge Guide
Screw, Edge Guide Retaining
Prepare unit for storage after each use by performing the following steps:
,_WARNING:
•Stop tile unit and disconnect the power source when not in use.
•Carry the unit with motor stopped.
•Store the unit so the line limiter blade cannot cause injury.
PART NUMBER
530402657
530401989
530016152
530402672
530402663
530015815
•Store unit and extension cord in-
doors in a high, dry place out of the reach of children. Store unit un-
plugged.
•Store unit with all guards in place. Position unit so that any sharp ob- ject cannot accidentally cause injury.