Fitting your own extension cable

◆When making your own extension cable, fit a 13 Amp plug to one end of the cable

(see “Mains plug replacement”) and a female connector to the other end. For wiring instructions, see those supplied with the female connector.

◆A male connector (see below) is already attached to the power supply cable on your tool. It is non-rewireable and should not be removed. If the connector is damaged and needs replacement, take the tool to a Black & Decker service centre.

female connector

male connector

Never wire an extension cable with anything other than the female connector supplied and a 13 Amp BS1363A approved plug with the recommended fuse. Never wire a male connector to the extension cable. Never wire an extension cable with a plug of any kind at each end of the cable. This is extremely dangerous and results in the pins being live, which may cause a fatal electric shock.

CARTON CONTENTS

The carton contains:

1Hedgetrimmer

1Blade sheath

1Guard

2Screws

1Instruction manual

◆Carefully unpack all parts.

◆Please note that additional items may be found in the carton, depending on the letter suffix following the catalogue number of your tool.

OVERVIEW (fig. A)

1.Front handle switch

2.Trigger switch

E N G L I S H

3.Front handle

4.Guard

5.Blade

6.Blade sheath

ASSEMBLY

Before assembly, make sure that the tool is switched off and unplugged.

Fit the blade sheath over the blades.

You will need a number 2 Posidrive screwdriver for assembly.

Fitting the guard (fig. B)

◆Place the guard (4) onto the tool as shown.

◆Secure the guard using the two screws supplied.

Never use the tool without the guard.

Connecting the tool to the mains (fig. C)

Unless the tool is fitted with a mains cable, you will need to connect an extension cable to the power inlet.

◆Connect the female socket of a suitable extension cable to the power inlet.

◆Loop the extension cable through the cable restraint (7) as shown to prevent it from becoming detached during use.

◆Insert the mains plug into a mains outlet.

The extension cable must be suitable for outdoor use.

USE

Let the tool work at its own pace.

Do not overload.

◆Carefully guide the cable in order to avoid accidentally cutting it. A good way to control the cable is by putting it over your shoulder.