Snapper 3500 PSI Pressure Washer
IMPORTANT: Read entire owner’s manual before you PREPARING PRESSURE attempt to assemble or operate your new pressure washer.
REMOVE PRESSURE
WASHER FROM
CARTON
•Remove all accessories and parts bag included with pressure washer.
•Slice two corners at the end of carton from top to bottom so the panel can be folded down flat, then remove all packing material.
•Roll pressure washer out of carton.
Carton Contents
Items in the carton include:
•Main unit
•High pressure hose
•Handle
•Pump oil dipstick (hanging on pump)
•(2) bottles of engine oil
•Safety goggles
•Spray gun with quick connect fitting
•Nozzle extension with quick connect fitting
•Accessory bag (includes the following):
•Owner’s registration card
•Nozzle cleaning kit
•Bag containing 5
•
•Owner’s manual
•Engine manual
•Handle hardware, including one carriage bolt, one “L” bolt and 2 plastic knobs
If any of the above parts are missing or damaged, contact the local Snapper service center.
WASHER FOR USE
If you have any problems with the assembly of your pressure washer or if parts are missing or damaged, contact the local Snapper service center.
To prepare your pressure washer for operation, you will need to perform these tasks:
•Fill out and send in the registration card.
•Attach the handle to the main unit.
•Add oil to the engine.
•Add fuel to the fuel tank.
•Connect the high pressure hose to the spray gun and the pump.
•Connect the water supply to the pump.
•Connect nozzle extension to spray gun.
•Select and install desired nozzle.
Attach Handle to the Pressure Washer
•Place the handle onto the handle supports already connected to the main unit. Make sure the holes in the handle align with the holes on the handle supports. (Figure 1)
Figure 1 — Attach the Handle to the Base
Make sure the |
|
| Handle | ||||
holes on the |
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
handle are |
|
|
|
|
|
|
|
aligned with the |
|
|
|
|
|
|
|
holes on the |
|
| Handle |
|
|
|
|
handle supports |
|
|
|
|
|
| |
|
|
| |||||
|
| Supports |
|
|
|
| |
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
NOTE: It may be necessary to move the handle supports from side to side in order to align the handle so it will slide over the handle supports.
•Insert the carriage bolt through the hole on the left side of the handle (viewing from rear of unit) and attach the plastic knob (Figure 2). Tighten the knob by hand.
5