Meade TE688W user manual Power, FCC Statement

Page 21

RF range: Maximum 100 feet (30 meters)

Temperature transmission cycle: approximately 45 seconds Low battery indicator

Wall-mount or Table stand

Power

Main unit: 2 AA size (UM-3) 1.5V batteries (not included)

Remote Sensor: 2 AA size 1.5V batteries (not included)

Dimensions

Main unit: 3.47(L) x 7.28(H) x 1.10(D) inches/ 88(L) x 185(H) x 28(D) mm

Remote sensor: 2.37(L) x 4(H) x 1(D) inches / 60(L) x 101(H) x 25(D) mm

FCC STATEMENT

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation.

Warning: Changes or modification to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

NOTE: This equipment had been tested and found to comply with the limits for a Class B Digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment, installed and used in accordance with the instructions, may cause harmful interference to radio communications.

There is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to improve or correct turning the interference by one or more of the following measures:

Reorient or relocate the receiving antenna

Increase the separation between the equipment and receiver.

Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.

Consult the dealer or an experienced radio / TV technician for help.

21

Image 21
Contents TE688W Introduction Before YOU Begin InstallationFeatures Placement Battery InstallationMounting OperationMain Unit TimeWeather Page Alarm button Mode buttonChannel button MEM/ History button UP ? buttonWALL- Mount hole Table StandPressure Operation Getting Started Weather ForecastSelect Pressure Units of Measure Viewing PRESSURE, Temperature and Humidity Charts Changing Pressure and Altitude UnitsViewing SEA Level Pressure History TEMPERATURE/ Humidity Window Moon Phase IconsRemote Sensors Status Icon StatusProgramming Temperature in Celsius or Fahrenheit Viewing Remote Channel Temperature and HumiditySetting Temperature Alarm Activating or Deactivating Temperature AlarmsComfort Level Indication Resetting Temperature MemoriesClock Window Wwvb Radio Controlled TimeIcon Atomic Time Reception Strength Manual SettingsSetting the Weekday and Single DAY Alarms Clock AlarmsTime Zone Time and CalenderACTIVATING/ Deactivating Alarms Setting the ICE Warning AlarmCleaning MaintanancePrecautions TroubleshootingMain Unit Indoor Temperature SpecificationsFCC Statement PowerDeclaration of Conformity Battery Safety InstructionsStandard Warranty Information Meade Instruments Corp