Section 3 – MAINTENANCE
WARNING
DO NOT attempt any maintenance, adjustments or service with engine and blade running. STOP engine and blade. Disconnect spark plug wire and secure away from spark plug. Engine and components are HOT. Avoid serious burns, allow sufficient time for all components to cool. Wear heavy leather gloves when handling or working around cutting blades. Blades are extremely sharp and can cause severe injury.
3.3.4. Wheel Drive Components
1.Remove rear cover. Refer to Section “Rear Cover Removal & Installation”.
2.Clean debris buildup on or around transmission, axles, idler, pulleys, belt, etc., as well as on underside of cover. Check components for wear or damage. Replace worn or damaged components immediately.
3.Replace rear cover.
IMPORTANT: DO NOT operate mower without rear cover securely in place.
3.4 STORAGE PROCEDURE
Refer to the Engine Owner’s Manual for directions regarding engine storage preparations. Prepare the mower for “end of season” storage as follows:
1.Drain fuel from fuel tank and let engine run until all fuel is out of the carburetor.
2.Disconnect and remove the spark plug wire away from spark plug before any other preparations are made!
3.Tape all openings closed to prevent spraying water into exhaust or air intakes during washing.
4.Tilt mower up on its rear wheels and thoroughly clean the underside of the deck. Do not tilt mower with spark plug or carburetor down. Scrape away any accumulation of grass with a putty knife and or wire brush.
5.Lubricate all exposed metal with a light coating of oil to prevent corrosion.
6.On
7.Carefully fold the handles, “flexing” the control cables to prevent cable damage.
8.Store the mower in a shed or other dry area, protected from weather.
12