Snapper S21, SP21, SPV21, SPV21S, SPV21E Cutting Height Adjustment, Each Notch Raises CUT

Page 9

Section 2 - OPERATING INSTRUCTIONS

WARNING

DO NOT attempt any maintenance, adjustments or service with engine and blade running. STOP engine and blade. Disconnect spark plug wire and secure away from spark plug. Engine and components are HOT. Avoid serious burns, allow sufficient time for all components to cool.

2.5CUTTING HEIGHT ADJUSTMENT

1. Pull the height adjusting latch outward and move to desired cutting height. See Figure 2.10.

EACH NOTCH RAISES CUT 0.5”

LATCH

POSITIONS

4.2”

1.2”

CUTTING HEIGHT SETTINGS

FIGURE 2.11

WARNING

Stop engine and mower blade by releasing the blade control before adjusting cutting height.

2.6 RECYCLING OPERATION

NOTE: For best recycling results, cut up to a maximum of 1/3 of grass blade length and recycle ONLY when grass is dry.

1. Set all wheels in the highest cutting position (Notch

7). Refer to Section “Cutting Height Adjustment”.

HIGHEST CUTTING HEIGHT

HIGHEST CUTTING HEIGHT

4

5

6

7

7

3

6

2

5

4

LOWEST CUTTING

1 HEIGHT

LATCH (IN

NOTCH # 4)

FRONT WHEEL (EXCEPT SPV21S)

3

2

 

LOWEST

1 CUTTING HEIGHT

LATCH (IN

NOTCH # 4)

REAR WHEEL (SPV21S FRONT WHEEL SIMILAR)

2.

Move engine speed control to “FAST” (Rabbit)

position.

3.

Move ground speed control to slowest speed

setting.

4.

Proceed mowing slowly. If grass is very dense,

lower each rear wheel latch one notch lower than the

front wheel latches to improve recycling performance.

NOTE: The recycling cover should remain on the machine at all times, unless alternate discharge operations are desired, such as side discharging or bagging.

TO REMOVE RECYCLING COVER:

Remove knob nuts and internal/external tooth lock washers securing recycling cover to mower deck. Remove cover. See Figure 2.12.

REMOVE KNOB NUTS

AND LOCK WASHERS

FIGURE 2.10

2.Set all wheels at the same cutting height. The highest cutting position is Notch 7. The lowest cutting position is Notch 1. See Figure 2.11.

FIGURE 2.12

9

Image 9
Contents ‘Easy Line’ Variable Speed Model Self Propelled Model Option Designation Cutting Width21 21 Cutting Width Swivel Front Wheels Electric Start From Previous Column Important Safety InstructionsDo not refuel the machine indoors From PreviousImportant Safety Instructions Table of Contents Nomenclature Model SPV21 Shown IntroductionEngine & Blade PRE-START Check List Starting & OperationHandle Height Adjustment Propelling Mower Self Propelled Models OnlyStopping Each Notch Raises CUT Cutting Height AdjustmentRecycling Operation To Remove Recycling CoverInstallation of Grass BAG Installation of Side DischargeDeflector Door Type BagService Periodic Service After First 5 Hours 3.2.1. Change Engine OILCheck Mower Blade Check Engine Drive BeltStorage Procedure Blade Sharpening Mower Blade Replacement Standard Blade Wear LimitTop of transmission pulley removed for clarity Wheel Drive Control AdjustmentTo adjust idler spring tension To decrease minimum ground speedTo increase minimum ground speed Engine Drive Belt Replacement 1. Empty fuel tank Belt ServiceBattery Service Battery Service NEW Battery PreparationBattery Storage Battery TestingRear Cover Removal & Installation Problem Probable Cause Corrective Action TroubleshootingMAINTENANCE/REPLACEMENT Parts Service Performed Each100 USE HRS SeasonDisclaimer of Warranty Year Limited WarrantyPrimary Maintenance Primary Maintenance Primary Maintenance Primary Maintenance Snapper Product Registration Form Page 21 ‘EASY LINE’ Walk Behind Mowers