Snapper MR216518B, MRP216518B Install Slide Discharge Deflector Slot Under NUT

Page 11

Section 2 - OPERATING INSTRUCTIONS

WARNING

DO NOT attempt any maintenance, adjustments or service with engine and blade running. STOP engine and blade. Disconnect spark plug wire and secure away from spark plug. Engine and components are HOT. Avoid serious burns, allow sufficient time for all components to cool.

2.12INSTALLATION of DISCHARGE DEFLECTOR (Optional accessory on some models)

Install discharge deflector if discharging is desired. Grass Bag and Bag Adapter or Recycling Cover must be removed.

1.Remove front and rear nuts that secure Bag Adapter or Recycling Cover to deck. Refer to sections concerning these parts.

2.Install discharge deflector and secure to deck using hardware removed in Step 1. Slot in front edge of discharge deflector must be under nut as shown and both bolts protruding through holes in the side of the deflector. See Figure 2.16.

INSTALL

 

SLIDE

DISCHARGE

 

DEFLECTOR SLOT

DEFLECTOR

 

UNDER NUT

 

 

 

2.13INSTALLATION of RECYCLING COVER (Optional Accessory on Some Models)

It will be necessary to remove bag adapter and grass bag or discharge deflector before installing recycling cover. See previous section for instructions. Install the recycling cover and secure to the side and top of the deck with the two nuts provided on the machine. Slide top portion of cover under nut secured to the deck. See Figure 2.17.

RECYCLING

COVER

ATTACH RECYCLING

COVER TO THE DECK

WITH TWO NUTS

FIGURE 2.17

INSTALL

NUTS

FIGURE 2.16

WARNING

DO NOT operate without entire Grass Catcher or guard in place. Grass Catcher components are subject to deterioration during normal use. Inspect frequently and replace worn or damaged components immediately.

WARNING

Grass Catcher bags used on SNAPPER products are made of woven fabric, and are subject to deterioration and wear during normal usage. Check condition of bag before each use. Immediately replace worn or damaged catcher bags with only bags recommended by SNAPPER. The grass catcher is optional equipment on some models.

11

Image 11
Contents Model Number Explanation Steel Deck Walk Mowers Type ‘M’ SeriesImportant Safety Instructions From Previous Column From PreviousDo not refuel the machine indoors Important Safety Instructions Table of Contents Introduction Provided for reference only and may differ fromYour specific model. Contact your Snapper Dealer if you have questionsStarting & Operation 2.2.1. Engine & Blade PRE-START Check ListPropelling Mower Self Propelled Models Only Handle Height AdjustmentCutting Height Adjustment Starting & OperationOn Next Recycling OperationRemoving and Dumping Grass Catcher Slide Closure Type BAGInstall Slide Discharge Deflector Slot Under NUT Service After First 5 Hours 3.2.1. Change Engine OIL MaintenanceCheck Engine Drive Belt Service AnnuallyStorage Procedure Check Mower Blade1.A. Ninja Blade Wear Limit Mower Blade Replacement Standard Blade Wear LimitBlade Sharpening Wheel Drive Control Adjustment Driven Disc Adjustment Driven and Drive Disc ServiceCleaning Drive Disc & Driven Disc Drive Spring Repair/ReplacementReplacing Rubber Driven Disc Driven Disc Assembly Install NEW Snap Rings Engine Drive Belt Replacement Stretch Type Belts Belt ServicePulley Position Battery Service 1. Remove battery Battery ServiceNEW Battery Preparation 1. Remove battery from carton Battery TestingCorrective Action Problem Probable CauseUSE HRS Season Service Performed EachMAINTENANCE/REPLACEMENT Parts 100Disclaimer of Warranty Year Limited WarrantyPrimary Maintenance Primary Maintenance Primary Maintenance Primary Maintenance Snapper Product Registration Form Page Page Steel Deck Walk Behind Mowers Type ‘M’ Series