Section 3 - MAINTENANCE
3.3.4.TRACTOR LUBRICATION (Continued From Previous Page)
3. Clutch/Brake Pivot
The clutch/brake pivot is located on the L.H. underside of the tractor and is lubricated with one shot of general purpose grease. See Figure 3.7.
CLUTCH/BRAKE
PIVOT LUBRICATION
FITTING
FIGURE 3.7
4. Steering Sector Gear
Lubricate with a light coat of general purpose grease. See Figure 3.8.
LUBRICATE
STEERING
SECTOR GEAR
LUBRICATE
STEERING
SHAFT GEAR
FIGURE 3.8
5. Steering Shaft
Lubricate steering shaft wear points with a light coat of 30 wt. Motor oil.
6. Steering Drag Link
Lubricate both ends of steering drag link with a small amount of 30 wt. motor oil from an oil can. See Figure 3.9.
DRAG LINK
LUBRICATION
POINT
FIGURE 3.9
7. Steering Tie Rod
Lubricate both ends of steering tie rod with a small amount of 30 wt. motor oil from an oil can. See Figure 3.10.
LUBRICATE
BOTH ENDS
OF TIE ROD
FIGURE 3.10
8. Park Brake Lever
Using 30 wt. motor oil, lubricate the park brake lever mechanism pivot points, which are located on the left hand underside of tractor. See Figure 3.11. Lubricate mechanism with a thin coat of 30 wt. motor oil.
PARK BRAKE
LEVER
LUBRICATE
COMPONENTS ON
UNDER OF TRACTOR
FIGURE 3.11
9. Deck Lift Mechanism
Lubricate all wear and pivot points of the deck lift.
13