Snapper CP215518HV, CP216018KWV, CRP216018KWV important safety instructions

Page 10

Section 2 - OPERATING INSTRUCTIONS

WARNING

DO NOT attempt any maintenance, adjustments or service with engine and blade running. STOP engine and blade. Disconnect spark plug wire and secure away from spark plug. Engine and components are HOT. Avoid serious burns, allow sufficient time for all components to cool.

2.8 INSTALLATION of GRASS CATCHER (Slide Closure Type)

Position grass bag between handles. Install grass catcher by sliding connector over flange of adapter. Attach grass bag hooks over middle handle cross bar. See Figure 2.12.

HOOK BAG HANDLE

OVER LOWER

HANDLES

SLIDE BAG

CONNECTOR OVER

END OF ADAPTER

FLANGE

FIGURE 2.12

2.9REMOVING and DUMPING GRASS CATCHER (Slide Closure Type)

1.Grasp bag connector and bag handle as shown. See Figure 2.13.

2.Lift up on bag handle, removing it from the mower handle. Then lift up on bag connector removing it from the adapter flange.

FIGURE 2.13

3.Dump bag by pulling bag slider off of Z-Fold at rear of bag, opening bag. See Figure 2.14

4.To close bag, fold rear of bag into Z-shape, keeping edges aligned. Note: an illustration of folding the Z-shape is attached to the bag.

5.Grasp the edge of the Z-fold, and while holding the slider, pull the Z-fold fully into the slider. See Figure 2.14.

GRASP SLIDER. PULL Z-

FOLD INTO SLIDER

PULL

FIGURE 2.14

10

Page 9 Page 11
Image 10
Page 9 Page 11
Contents Steel Deck Walk Mowers Commercial Models Series Important Safety Instructions Do not refuel the machine indoors From PreviousFrom Previous Column Important Safety Instructions Table of Contents Introduction Engine Speed ControlNomenclature PRE-START Check List Starting & Operation Engine & BladePropelling Mower Handle Height AdjustmentCutting Height Adjustment StoppingRefer to Section Operating Instructions Recycling Operation Removing and Dumping Grass Catcher Slide Closure Type Recycling Operation Service After First 5 Hours 3.2.1. Change Engine OIL Dispose of drain oil properlyCheck Mower Blade Service AnnuallyStorage Procedure Check Engine Drive BeltBlade Sharpening Mower Blade Replacement Standard Blade Wear Limit1.A. Ninja Blade Wear Limit Wheel Drive Control Adjustment Drive Spring Repair/Replacement Driven and Drive Disc ServiceCleaning Drive Disc & Driven Disc Driven Disc AdjustmentOn Next Replacing Driven Disc Rubber Ring Remove bearing and replace with new bearing Reassemble components in reverse orderEngine Drive Belt Replacement Stretch Type Belts Belt ServiceOn Next Reinstall blade hub and cutter blade Pulley PositionProblem Probable Cause Corrective Action100 Service Performed EachMAINTENANCE/REPLACEMENT Parts USE HRS SeasonYear Limited Warranty Disclaimer of WarrantyPrimary Maintenance Primary Maintenance Primary Maintenance Primary Maintenance Snapper Product Registration Form Page Page Page Steel Deck Walk Behind Mowers Commercial Models Series
Top Page Image Contents