Snapper CP215518HV, CP216018KWV, CRP216018KWV Engine Speed Control, Introduction, Nomenclature

Page 6

Section 1 - FAMILIARIZATION

WHEEL DRIVE

CONTROL

ENGINE

SPEED

CONTROL

ROPE

START

HANDLE

GRASS

BAG

REAR HEIGHT

ADJUSTMENT

LATCH

BLADE

CONTROL

GROUND SPEED

CONTROL

OIL FILL

AND DIPSTICK

FUEL FILL

ENGINE

SPEED

CONTROL

CHOKE

FAST

SLOW

GRASS BAG ADAPTER

FRONT HEIGHT

ADJUSTMENT LATCHES

FIGURE 1.1

1.1 INTRODUCTION

This manual has been prepared for the operators of the SNAPPER WALK BEHIND MOWERS. Its purpose, aside from recommending operating and routine service requirements, is to promote safety through the use of accepted operating practices. Read, Understand and Follow the “IMPORTANT SAFETY INSTRUCTIONS” on Pages 2 - 4 of this manual and all safety messages on the mower and attachments before operating the mower.

1.2 NOMENCLATURE

The nomenclature drawing above, Figure 1.1, shows the essential parts of the SNAPPER WALK BEHIND MOWERS. It is recommended that all operators of the mower become thoroughly familiar with the controls, parts and operation of the mower before operating. Specific details involving the engine are found in the separate engine owner’s manual. Study these manuals before operating and keep both handy for future reference.

6

Image 6

Contents Steel Deck Walk Mowers Commercial Models Series Important Safety Instructions From Previous Do not refuel the machine indoorsFrom Previous Column Important Safety Instructions Table of Contents Engine Speed Control IntroductionNomenclature PRE-START Check List Starting & Operation Engine & BladePropelling Mower Handle Height AdjustmentCutting Height Adjustment StoppingRefer to Section Operating Instructions Recycling Operation Removing and Dumping Grass Catcher Slide Closure Type Recycling Operation Service After First 5 Hours 3.2.1. Change Engine OIL Dispose of drain oil properlyCheck Mower Blade Service AnnuallyStorage Procedure Check Engine Drive BeltMower Blade Replacement Standard Blade Wear Limit Blade Sharpening1.A. Ninja Blade Wear Limit Wheel Drive Control Adjustment Drive Spring Repair/Replacement Driven and Drive Disc ServiceCleaning Drive Disc & Driven Disc Driven Disc AdjustmentOn Next Replacing Driven Disc Rubber Ring Remove bearing and replace with new bearing Reassemble components in reverse orderBelt Service Engine Drive Belt Replacement Stretch Type BeltsOn Next Reinstall blade hub and cutter blade Pulley PositionProblem Probable Cause Corrective Action100 Service Performed EachMAINTENANCE/REPLACEMENT Parts USE HRS SeasonYear Limited Warranty Disclaimer of WarrantyPrimary Maintenance Primary Maintenance Primary Maintenance Primary Maintenance Snapper Product Registration Form Page Page Page Steel Deck Walk Behind Mowers Commercial Models Series