FEATURES OF THE CONSOLE
The
HOW TO OPERATE THE CONSOLE
Make sure there are batteries in the console (see BATTERY REPLACEMENT on page 10). If there is a thin sheet of clear plastic on the console, remove it.
Follow the steps below to operate the console.
1.To turn on the power, press the On/Reset button or begin pedaling. The entire display will briefly appear; the console will then be ready for use.
2. Select one of the modes:
Scan mode—
When the power is turned on, the scan mode will be
selected automati- cally. A mode indi- cator will appear below the word “SCAN” to show that the scan
mode is selected, and a second
mode indicator will show which mode is currently displayed. Note: If you have selected a different mode, repeatedly press the Mode button to rese- lect the scan mode.
Speed, time, dis- tance, or calorie mode—To select
one of these modes for continu- ous display, repeatedly press the Mode button. The mode indica-
tors will show
which mode is selected. Make sure there is not a mode indicator below the word “SCAN.”
Note: The console can display speed and dis- tance in either miles or kilometers. To change the unit of measurement, press the On/Reset button for about five seconds. The letters mph or km/h will appear in the display to show which unit of measurement is selected. When the batteries are replaced, it may be necessary to reselect the desired unit of measurement.
3.To reset the display at any time, press the On/Reset button.
4.To turn off the power, simply wait for a few minutes.
The console has an
9