3 | unit assembly |
|
INSERT PIN |
| |
INTO ROD | SLIDE ROD | |
|
| |
|
| THROUGH |
|
| HOLES |
HOOK BAGGER |
| |
FRAME ONTO |
| |
BUMPER MOUNT |
| |
PLATE PINS |
|
STEP 13: Hook bottom of bagger frame onto pins in bottom of bumper mount plate. Then slide lock- ing rod through aligned holes in bagger frame and bumper mount plate, securing with bridge pin.
CROSS ASSEMBLY
INSTALL REINFORCEMENT PLATE ON BACK SIDE OF BAGGER FRAME
COVER LATCH ARM
STEP 14: Install cross assembly onto bagger frame with four
STEP 15: Insert two
-Catcher Mount Group), then through holes in bagger frame. Install cover latch arm onto bolts and secure with hex flange lock nuts, tightening securely. NOTE: Use the leftmost set of holes in the bagger frame when installing arm.
| HAIR PINS |
| HINGES |
| ROUND |
ROUND | HEAD PIN |
HEAD PIN |
|
STEP 16: Lay cover assembly on cross assembly. Align hinges on cross assembly with hinges on cover, and install one round head pin through each set of hinge holes, securing with a hair pin.
SLIP CORD ONTO STUD AND SECURE WITH WASHER & NUT
STEP 17: Slip looped end of cover support cord onto threaded stud on hose adapter assembly. Secure end of cord with one 3/16” flat washer and
8