Snapper CP216017RV, CP215017KWV, CP215017HV, CP215017HV guide

Section 4 - REPAIR & ADJUSTMENTS

WARNING

DO NOT attempt any maintenance, adjustments or service with engine and blade running. STOP engine and blade. Disconnect spark plug wire and secure away from spark plug. Engine and components are HOT. Avoid serious burns, allow sufficient time for all components to cool.

4.4.1.Engine Drive Belt Replacement (Stretch Type Belts)

(Continued From Previous Page)

IMPORTANT: Drain fuel tank before tipping machine. DO NOT tip machine with carburetor or spark plug down. Oil from crankcase will saturate the air filter and cause the engine to be hard to start or not start at all. If contamination does occur, the air filter will have to be replaced.

3. Remove the driven disc. Refer to Section

“Replacing Rubber Driven Disc Ring” for driven

disc assembly removal procedure.

4. Tilt mower up on its rear wheels and remove

blade and blade hub. Assistance from another

person may be necessary to hold mower in the

tilted position.

PULLEY POSITION

DRIVE DISC

SLOT IN END OF DRIVE DISC BOLT

BUSHING

DECK BRACKET

(PARTIALLY SHOWN)

BOLT RETAINER

INTERNAL TOOTH

LOCKWASHER

NUT

FIGURE 4.16

4.4.2.Transmission Poly-V Belt Replacement

1.Remove the driven disc. Refer to Section Replacing Driven Disc Rubber Ring” for procedure.

2.Note the routing of the old belt around the three pulleys before removing it. See Figure 4.17.

5. Hold the slotted end of the drive disc bolt with a

screwdriver and remove the nut and internal tooth

lock washer. See Figure 4.16.

DRIVE

IDLER

PULLEY DIFFERENTIAL BRACKET

6.	Remove the belt cover located under deck.
7.	Lift the drive disc up and remove worn belt.
8.	Loop one end of new belt over engine pulley and
insert the other end through slot in deck. See
Figure 4.15.
9.	Loop the belt around the pulley on the bottom of
the drive disc.
10. Reinstall drive disc and retaining hardware.
IMPORTANT: 1) The square shoulder of the drive
disc bolt must fit into the square hole of the
bushing. 2) The square end of bushing must fit into
the bracket slot.
11. Reinstall belt cover and tighten bolts securely.
12.	Reinstall blade hub and cutter blade.

Recommended torque for blade cap screw is	30
to 40 ft. lbs.

PULLEYPOLY-V

BELT

HEX SHAFT

BELT GUIDE	DRIVEN
	PULLEY

ROUTING OF POLY-V

BELT

FIGURE 4.17

3.Place new Poly-V Belt over end of hex shaft and onto driven pulley.

4.Work belt onto top of idler pulley.

5.Twist belt sideways and pull it upward between the differential bracket and drive pulley and then down into the pulley groove. Make sure the Poly-V Belt is above belt guide. See Figure 4.17.