Section 2 - OPERATING INSTRUCTIONS
2.4 HANDLE HEIGHT ADJUSTMENT | 2. Set all wheels at the same cutting height. The |
The height of the mower handle can be adjusted | highest cutting position is Notch 6. The lowest |
as follows: | cutting position is Notch 1. See Figure 2.9. |
1. Loosen the nuts on each lower handle as shown in Figure 2.7.
HIGHER | LATCH |
LOWER | POSITION |
| |
HANDLE |
|
LOWER
CUTTING HEIGHT SETTINGS
FIGURE 2.9
LOOSEN LOWER
NUTS ON EACH
LOWER HANDLE
FIGURE 2.7
IMPORTANT! Some models are equipped with braces that attach to the lower handle brackets and must be loosened before handle height can be adjusted.
2.Move upper mower handle up or down until the desired position is achieved.
3.Tighten the lower nuts on each lower handle to maintain desired position.
WARNING
STOP engine and mower blade by releasing the blade control before adjusting cutting height or handle height.
2.5CUTTING HEIGHT ADJUSTMENT
1. Pull the height adjusting latch outward and move to desired cutting height. See Figure 2.8.
1
LOWEST CUTTING | LATCH |
HEIGHT |
1
2
3
4
5
6
HIGHEST CUTTING HEIGHT
6
FIGURE 2.8
8