Snapper 7800602, 7800600 Installing the Grass Bag, Installing the Recycling Plug, Door Type Bag

Operation (Continued)

! WARNING !

DO NOT attempt any maintenance, adjustments or service with engine and blade running. STOP engine and blade. Disconnect spark plug wire and secure away from spark plug. Engine and components are HOT. Avoid serious burns, allow sufficient time for all components to cool.

Installing the Grass Bag

(Door Type Bag)

1.Install the grass bag adapter. Refer to the Section entitled “Installing the Grass Bag Adapter”.

2.Install the grass bag by sliding the connector (A, Figure 12) over the adapter flange.

3.Attach the grass bag hooks (B) over the middle handle cross bar.

Installing the Recycling Plug
(Optional Accessory on Some Models)	B
1. Install the recycling plug (A, Figure 11) if recycling is
desired after the bag adapter is installed. Install the	A
recycling plug completely and securely into the bag
adapter (B).

!	WARNINGReproduct!ion
	A
	B		Fig	re 12: Installing the grass bag
			!	WARNING	!
Figure 11: Installing the recycling plug			Grass Catcher bags used SNAPPER products are made
			of woven fabric, and are subject to deterioration and wear
2. Install the grass bag as a safeguard.			during normal usage. Check condition of bag before each
			use. Immediately replace worn or damaged catcher bags
3. Refer to the Section entitled “Recycling Op		ration”.
			with only bags recommended by SNAPPER. The grass
			catcher is optional equipment on some models.
DO NOT operate without entire Grass Catcher or guard
in place. Grass Catcher components are subject to
deterioration during normal use. Inspect frequently and
replace worn or damaged components immediately.

Operation

11