Esoteric I-03 owner manual Specifications

Page 20

Specifications

Speaker Outputs

Rated output power. . . . . . . . . . . . 240 W + 240 W (1 kHz, 6 Ω) Maximum output power

320 W + 320 W (1 kHz, 0.1 %, 6 Ω) (JEITA) Total harmonic distortion. . . . . . . . . . . . . . 0.03 % (1 kHz, 6 Ω) Frequency response. . . . . . . . . . 5 Hz - 70 kHz (+1 dB, –3 dB, 6 Ω) Signal-to-noise ratio (S/N). . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 110 dB (JEITA) Minimum required impedance.. . . . . . . . . . . . . . . . . . 4 Ω Speaker output terminals. . . . . . . . . . . Binding posts x 1 stereo

Analog audio inputs

Jacks. . . . . . . . . . . . . . . . . . . . . . . RCA jacks x 3 stereo RCA2: can be connected to an AV-amplifer’s pre-output

RCA3: can be switched among LINE, PHONO MM and PHONO MC XLR jacks x 2 stereo Input impedance. . . . . . . . . . . . . . . . . . . . . LINE: 100 kΩ PHONO MM: 47 kΩ PHONO MC: 100 kΩ

Analog audio outputs

Jacks. . . . . . . . . . . . . . . . . . . . . . . RCA jacks x 1 stereo Output impedance. . . . . . . . . . . . . . . . . . . . . . . .470 Ω

General

Power supply

European model . . . . . . . . . . . . . . . . . . AC 230 V, 50 Hz U.S.A./Canadian model. . . . . . . . . . . . . . . AC 120 V, 60 Hz Korean model. . . . . . . . . . . . . . . . . . . AC 220 V, 60 Hz Power consumption. . . . . . . . . . . . . . . . . . . . . . 280 W

External dimensions (W x H x D)

445 x 162 x 468 mm (17 1/2” x 6 3/8” x 18 3/8”) (including protrusions)

Weight. . . . . . . . . . . . . . . . . . . . . . . . . . 31 kg (68 lb) Operating temperature. . . . . . . . . . . . . . . . .+5 °C to +35 °C Operating humidity . . . . . . . . . . .5 % to 85 % (no condensation) Storage temperature . . . . . . . . . . . . . . . . . –20 °C to +55 °C

20

Accessories

Remote control unit (RC-1251) x 1

Batteries (AA, R6 or SUM-3) x 2

Power cord x 1

Felt pads x 3

Owner’s manual (this document) x 1

Warranty card x 1

External dimensions

445mm (17 1/2”)

162mm (6 3/8”)

468mm (18 3/8”)

oDesign and specifications are subject to change without notice.

oWeight and dimensions are approximate.

oIllustrations may differ slightly from production models.

Image 20
Contents Integrated Amplifier D01141820AImportant Safety Instructions For U.S.AContents What’s in the boxBefore Use Placement of the unitMaintenance Power VolumeIdentifying the Parts Main Unit InputIdentifying the Parts Remote Control Unit Precautions concerning batteries Remote Control UnitBattery Installation Battery Replacement Audio OUT ConnectionsAudio GND terminal Signal GND Power cord receptacleAnalog audio input terminals Inputs Analog audio output terminals PRE OUTHow to connect Speaker ConnectionsSpeaker cables Right speakerUsing speaker cables with bare wire Using speaker cables with spadesUsing speaker cables with banana plugs Power amplifierXLR2 RCA1 RCA2 RCA3/PHONO Basic OperationTurning the unit off Listening with headphones Dimmer/MutingDimmer MutingBalance and Input Level Settings Return to the previous display Exit setup modeL6.0 dB Output level Display Level +18.0 dBAdditional Settings Changing settingsRCA3 MM/MCAvailable setup items and settings OFFON1 ON2Changing the terminal name LinePhono Returning to factory settings Display Setup Auto display darkening Display FLaOFF15m 30mTroubleshooting Protection CircuitSpecifications Rear Panel Layout Disposal of batteries and/or accumulators For European customersDisposal of electrical and electronic equipment China RoHS Teac Corporation