Esoteric I-03 owner manual Remote Control Unit, Battery Installation Battery Replacement

Page 7

Remote Control Unit

The included remote control allows this unit to be operated from a distance.

Point the remote control unit at the main unit’s remote sensor within 23 feet (7 m) of the main unit.

Remote sensor

7m

(23 feet)

o Depending on the angle, reception might be difficult. Use the remote control from directly in front of the unit as much as possible.

oEven if the remote control unit is used within its effective range, operation by remote control might be impossible if there are any obstacles between the unit and the remote control.

o If direct sunlight or strong artificial illumination shines on the remote sensor, the remote control might not function.

o If the remote control unit is operated near other devices that generate infrared rays, or if other remote controls that use infrared rays are operated near the unit, this unit might operate incorrectly. The other devices might also operate incorrectly.

Battery Installation

Battery Replacement

If the operating range between the remote control unit and main unit decreases, the batteries are exhausted. In this case replace the batteries with new ones.

For more information about collection of batteries, please contact your local municipality, your waste disposal service or the point of sale where you purchased the items.

Precautions concerning batteries

Misuse of batteries could cause them to rupture or leak leading to fire, injury or the staining of nearby things. Please read and observe the following precautions carefully.

o Be sure to insert the batteries with correct positive (¥) and negative (^) orientations.

o Use batteries of the same type. Never use different types of batteries together.

oBoth rechargeable and non-rechargeable batteries can be used. Refer to the precautions on their labels.

oIf the remote control will not be used for a long time (more than a month), remove the batteries to prevent them from leaking.

oIf the batteries leak, wipe away the leakage inside the battery compartment and replace the batteries with new ones.

oDo not use batteries of types other than those specified. Do not mix new batteries with old ones or use different types of batteries together.

oDo not heat or disassemble batteries. Never throw batteries into fire or water.

oDo not carry or store batteries with other metallic objects. The batteries could short circuit, leak or explode.

o Never recharge a battery unless it is confirmed to be a rechargeable type.

Use a Philips screwdriver to remove the cover from the bottom of the remote control, and slowly pull out the battery case. Insert two

AAbatteries in the correct ¥/^ orientations, reinsert the case and close the cover.

7

Image 7
Contents D01141820A Integrated AmplifierFor U.S.A Important Safety InstructionsWhat’s in the box ContentsMaintenance Placement of the unitBefore Use Input PowerVolume Identifying the Parts Main UnitIdentifying the Parts Remote Control Unit Battery Installation Battery Replacement Remote Control UnitPrecautions concerning batteries Audio ConnectionsAudio OUT Analog audio output terminals PRE OUT GND terminal Signal GNDPower cord receptacle Analog audio input terminals InputsRight speaker How to connectSpeaker Connections Speaker cablesPower amplifier Using speaker cables with bare wireUsing speaker cables with spades Using speaker cables with banana plugsTurning the unit off Basic OperationXLR2 RCA1 RCA2 RCA3/PHONO Muting Listening with headphonesDimmer/Muting Dimmer+18.0 dB Balance and Input Level SettingsReturn to the previous display Exit setup mode L6.0 dB Output level Display LevelMM/MC Additional SettingsChanging settings RCA3ON2 Available setup items and settingsOFF ON1Phono LineChanging the terminal name 30m Returning to factory settings Display SetupAuto display darkening Display FLaOFF 15mProtection Circuit TroubleshootingSpecifications Rear Panel Layout Disposal of electrical and electronic equipment For European customersDisposal of batteries and/or accumulators China RoHS Teac Corporation