Snapper 5900700 manual Starting After Long Term Storage, Temporary Storage 30 Days Or Less

Page 38

Maintenance

Regular Maintenance

Storage

Temporary Storage (30 Days Or Less)

Remember, the fuel tank will still contain some gasoline, so never store the unit indoors or in any other area where fuel vapor could travel to any ignition source. Fuel vapor is also toxic if inhaled, so never store the unit in any structure used for human or animal habitation.

Here is a checklist of things to do when storing your unit temporarily or in between uses:

Keep the unit in an area away from where children may come into contact with it. If there’s any chance of unauthorized use, remove the spark plug (s) and put in a safe place. Be sure the spark plug opening is protected from foreign objects with a suitable cover.

If the unit can’t be stored on a reasonable level surface, chock the wheels.

Clean all grass and dirt from the mower.

Long Term Storage (Longer Than 30 Days)

Before you store your unit for the off-season, read the Maintenance and Storage instructions in the Safety Rules section, then perform the following steps:

1.Drain crankcase oil while engine is hot and refill with a grade of oil that will be required when unit is used again.

2.Prepare the mower deck for storage as follows:

a.Remove mower deck from the unit.

b.Clean underside of mower deck.

c.Coat all bare metal surfaces with paint or light coat of oil to prevent rusting.

3.Clean external surfaces and engine.

4.Prepare engine for storage. See engine owner’s manual.

5.Clean any dirt or grass from cylinder head cooling fins, engine housing and air cleaner element.

6.Cover air cleaner and exhaust outlet tightly with plastic or other waterproof material to keep out moisture, dirt and insects.

7.Completely grease and oil unit as outlined in the Normal Care section.

8.Clean up unit and apply paint or rust preventative to any areas where paint is chipped or damaged.

9.Be sure the battery is filled to the proper level with water and is fully charged. Battery life will be increased if it is removed, put in a cool, dry place and fully charged about once a month. If battery is left in unit, disconnect the negative cable.

WARNING

Never store the unit, with gasoline in engine or fuel tank, in a heated shelter or in enclosed, poorly ventilated enclosures. Gasoline fumes may reach an open flame, spark or pilot light (such as a furnace, water heater, clothes dryer, etc.) and cause an explosion.

Handle gasoline carefully. It is highly flammable and careless use could result in serious fire damage to your person or property.

Drain fuel into an approved container outdoors away from open flame or sparks.

10.Drain fuel system completely or add a gasoline stabilizer to the fuel system. If you have chosen to use a fuel stabilizer and have not drained the fuel system, follow all safety instructions and storage precautions in this manual to prevent the possibility of fire from the ignition of gasoline fumes. Remember, gasoline fumes can travel to distant sources of ignition and ignite, causing risk of explosion and fire.

NOTE: Gasoline, if permitted to stand unused for extended periods (30 days or more), may develop gummy deposits which can adversely affect the engine carburetor and cause engine malfunction. To avoid this condition, add a gasoline stabilizer to the fuel tank and run the engine a few minutes, or drain all fuel from the unit before placing it in storage.

Starting After Long Term Storage

Before starting the unit after it has been stored for a long period of time, perform the following steps.

1.Remove any blocks from under the unit.

2.Install the battery if it was removed.

3.Unplug the exhaust outlet and air cleaner.

4.Fill the fuel tank with fresh gasoline. See engine manual for recommendations.

5.See engine owner’s manual and follow all instructions for preparing engine after storage.

6.Check crankcase oil level and add proper oil if necessary. If any condensation has developed during storage, drain crankcase oil and refill.

7.Inflate tires to proper pressure. Check fluid levels.

8.Start the engine and let it run slowly. DO NOT run at high speed immediately after starting. Be sure to run engine only outdoors or in well ventilated area.

36

www.SnapperPro.com

Image 38
Contents Model Number Briggs & Stratton Power Products GroupDescription Date Purchased Table of Contents Children Operating SafetyRead the Manual Moving Parts Safety Rules & InformationSlope Operation Thrown Objects Fuel and Maintenance Enclosed AreasOperation Periods of exposure Do NotMaintenance and Storage Safe Handling of GasolineOperator Safety Safety DecalsSafety Icons Safety Interlock SystemOperational Safety Checks North American Safety IconsFeatures and Controls Identification NumbersControl Functions Features and ControlsIgnition Switch Forward Speed Control Lever Reverse Speed Control LeversFeatures & Controls Checks Before Starting General Operating SafetyOperation Check Tire Pressures Pushing the Mower By HandCutting Height Adjustment To Adjust the Cutting RangeTo Adjust the Cutting Height Stopping the Mower Starting the EngineImpact Hazard To Move Backward See Figure Driving The MowerTo Move Forward and SET Forward Speed See Figure To make a left-hand turn See Figure To make a right-hand turn See FigureHeight of Grass MowingMowing Recommendations Tall Grass Requires Incremental CuttingMowing Methods Engine Speed & Ground Speed for Mulching Proper MulchingMulching Requires Excellent Mowing Conditions How Much Grass to MulchHours Fall Check Unit for Loose Hardware Maintenance ScheduleSafety Items Before Every Spring Checking / Adding Fuel Regular MaintenanceEngine Maintenance Fuel FilterOil LubricationGrease Lubricating the Front CastersTransmission Oil Filter Change Change Interval Every 200 Hours Replacement Filter NumberCheck / Fill Transmission Oil Never weld or straighten bent mower blades Servicing The Mower BladesInspecting the Mower Blades Reinstalling the Mower Blades Balancing the Mower Blade NailTo Reduce the Speed of the Faster Wheel Neutral AdjustmentSpeed Balancing Adjustment Parking Brake Adjustment Snapper Pro dealerDeck Leveling Adjustment To Level the Mower DeckMower Belt Replacement To avoid damaging belts, do not PRY Belts Over Pulleys12- 1/4 31,1 cmTransmission Drive Belt Replacement Use extreme caution when removing this springReverse Speed Control Levers Comfort Adjustment Reverse Speed Control Levers Comfort Adjustment Lock NutTemporary Storage 30 Days Or Less StorageStarting After Long Term Storage Long Term Storage Longer Than 30 DaysTroubleshooting the Mower TroubleshootingTroubleshooting Chart Problem Cause RemedyTroubleshooting the Mower Deck Not driveTroubleshooting Troubleshooting Common Cutting ProblemsEngine Power Rating Information SpecificationsSpecifications 13 HP* KawasakiSlope Indentification Guide Page Page Page Snapper PRO Limited Warranty Product Specifications Common Service Parts