Snapper 2600, 1600, LT Series Discharge Tube Assembly, Landlord / 1700 / 2700 Series

Installation Instructions Hitch & Tube Group

Landlord / 1700 / 2700 Series

NOTE: Do not tighten hardware until all components are installed.

1.Mount the hitch support (B, Figure 3) to the rear of the tractor using 3/8-16 x 1 capscrews and locknuts.

2.Secure the hitch bracket (A) to the hitch support (B) using 3/8-16 x 1 capscrews and locknuts.

3.Secure the hitch bracket (A) to the drawbar (E) using a 1/2-13 x 1-1/4 capscrew, washers (G), and locknut

(H).

4.Tighten all hardware.

DISCHARGE TUBE ASSEMBLY

1.Connect the flexible hose (F, Figure 4) and clear plastic discharge tube (B). The two should overlap by approximately 2”.

2.Secure the tubes using truss head screws (E), wash- ers (D), and locknuts (C). Insert the screws from the inside out and poke them through the flexible hose.

3.Insert the upper end of the clear tube into the cart sleeve. Slide the flex hose (F) over the turbo (H) and secure with the large hose clamp (G). The hose should overlap the turbo discharge by 2”-3”.

The clamp screw should be positioned to the inside as shown to prevent accidental impact and removal of the clamp.

Check that the upper end of the clear tube (B, Figure

4)is not contacting the top of the collector cover. If necessary, cut off the clear tube flush with the sleeve (See Wide Body Cart Operators Manual).

	C
	F
	G
C	D
			D
			E
	A	B	G
			H

Figure 3. Landlord Hitch Installation

A. Hitch Bracket	E. Drawbar
B. Hitch Support	F. Capscrew, 1/2-13 x 1-1/4
C. Capscrew, 3/8-16 x 1	G. Flat washer, 1/2
D. Locknut, 3/8-16	H. Locknut, 1/2-13

A

B

C

D

E

F

G

F

G

H

Figure 4. Discharge Tube Installation
A. Decal	E. Truss Head Screw
B. Discharge Tube	F. Hose
C. Locknut, Hose	G. Clamp
D. Washer	H. Turbo Discharge

MANUFACTURING, INC .	Form No. 1726331-00
	Rev. 12/2003
500 N Spring Street / PO Box 997	© 2003 Simplicity Manufacturing, Inc. All Rights Reserved
Port Washington, WI 53074-0997 USA	TP 200-4006-00-AT-SMA

2