Section 2 - OPERATING INSTRUCTIONS
2.3 | STOPPING |
| Stop engine and blade by releasing the blade |
| control. Stop forward motion of mower by releasing |
| the wheel drive control. |
2.4 | HANDLE HEIGHT ADJUSTMENT |
| The height of the mower handle can be adjusted as |
| follows: |
1 | LOWEST CUTTING | LATCH | |
HEIGHT | |||
|
1. Loosen the lower nuts on each lower handle as |
shown in Figure 2.5. |
HIGHER
LOWER
HANDLE
1
2
3
4
5
6
HIGHEST CUTTING HEIGHT
6
LOWER
LOOSEN LOWER
NUTS ON EACH
LOWER HANDLE
FIGURE 2.5
2.Move upper mower handle up or down until the desired position is achieved.
3.Tighten the lower nuts on each lower handle to maintain desired position.
WARNING
Stop engine and mower blade by releasing the blade control before adjusting cutting height or handle height.
2.5CUTTING HEIGHT ADJUSTMENT
1. Pull the height adjusting latch outward and move to desired cutting height. See Figure 2.6.
FIGURE 2.6
2.Set all wheels at the same cutting height. The highest cutting position is Notch 6. The lowest cutting position is Notch 1. See Figure 2.7.
LATCH
POSITIONS
CUTTING HEIGHT SETTINGS
FIGURE 2.7
7