Installation Instructions |
| Snowthrower |
| & Dozer |
| Applications |
A |
|
B | F |
C | |
D | E |
| |
| Mower |
| Applications |
A |
|
B | F |
| |
G | E |
Figure 5. Lift Lock Plate - Hydraulic Lift Models
A.Lift Cylinder
B.Flat Head Pin (Original)
C.Flat Head Pin (New)
D.Lock Plate
E.Hair Pin Clips
F.Lift Shaft Assy.
G.Washers
Snowthrower
& Dozer
E
Applications
A
B | C | D |
Mower |
|
|
Applications |
| G |
A |
|
|
F C D
Figure 6. Lift Link - Manual Lift Models
A.Pin
B.Rear Hole of Lift Bar (Snowthrower/Dozer Applications)
C.Spacer
D.Hair Pin Clip
E.Upper Hole (Snowthrower/Dozer Applications)
F.Slot of Lift Link (Mower Applications)
G.Lower Hole (Mower Applications)
Install Downward Pressure Lock
HYDRAULIC LIFT MODELS
1.Install the downward pressure lock plate (D, Figure 5) and an additional pin (C). Note that the washers (G) are not used with the lock plate.
MANUAL LIFT MODELS
NOTE: These instructions apply to Conquest / 1700 / 2700 Series tractors or Broadmoor / 1600 / 2600 Series tractors equipped with a lift lever kit.
1.Install the lift link as shown in the upper frame of Figure 6.
NOTE: The lift link on early model units had a hole locat- ed in front of the slot, rather than behind. These early model lift links must be removed and replaced with the one contained in this kit (Ref. No. 22, Figure 1). The lift link included with this kit (pictured above) is universal and works in all applications.
3