Lift Variations When Using Attachments

Sub-Frame Hitch

Installation Instructions

	Snowthrower
	& Dozer
	Applications
A
B	F
C	F
D	E
	E
	Mower
	Applications
A
B	F
	F
G	E

Figure 11. Lift Lock Plate - Hydraulic Lift Models

A.Lift Cylinder

B.Flat Head Pin (Original)

C.Flat Head Pin (New)

D.Lock Plate

E.Hair Pin Clips

F.Lift Shaft Assy.

G.Washers

Snowthrower

& DozerE

Applications

B	C	D
Mower
Applications		G
A

F C D

Figure 12. Lift Link - Manual Lift Models

A.Pin

B.Rear Hole of Lift Bar (Snowthrower/Dozer Applications)

C.Spacer

D.Hair Pin Clip

E.Upper Hole (Snowthrower/Dozer Applications)

F.Slot of Lift Link (Mower Applications)

G.Lower Hole (Mower Applications)

When a front-mounted attachment such as a snowthrow- er or dozer blade is used with the tractor, the lift mecha- nism must be locked to provide downward force. When the mower is reinstalled the downward pressure lock must be released so that the mower can float.

Hydraulic Lift Models

When using a snowthrower or dozer, the downward pressure lock plate (D, Figure 11) and an additional pin

(C)is installed. These parts are included with the attach- ment. Note that the washers (G) are not used with the lock plate.

When mowing, the downward pressure lock plate (D) is removed and replaced with two washers (G). The addi- tional pin (C) is also removed.

Fully lower the hydraulic lift. The lift assembly is spring loaded so it will need to be held in the down position to perform of the following procedures.

Manual Lift Models

NOTE: These instructions apply to Conquest / 1700 / 2700 Series tractors or Broadmoor / 1600 / 2600 Series tractors equipped with a lift lever kit.

The lift link is installed differently depending on what attachment is being used. Refer to Figure 12 for link installation information.