Telex 80 manual Technical Support

Page 11

IP-223 to Kenwood Radios

9

For the TK-x180, the AUX programming screen is different. Please note that the same interface cable is used for both the TK-x150 and TK-x180 radios. If COR is used, IP-223 Jumper 8 (Line

1)or Jumper 30 (Line 2) will have to be placed in a neutral position for the Aux port pin 20 on the TK-x180 to function properly as COR.

TK-x180 auxiliary setup screen

Suggestions or Comments

We’d appreciate your input. Please send us your suggestions or comments concerning this application note, by fax (402-467-3279) or e-mail them to: vega@telex.com

Technical Support:

Email address: acttechsupport@us.telex.com

Phone #: 1-800-898-6723

TELEX Communications, Inc.

Vega Signaling Products

8601 East Cornhusker Highway, Lincoln, Nebraska, 68507

Phone: (800) 752-7560 Fax: (402) 467-3279

E-mail: vega@telex.com, Web: www.vega-signaling.com

Page 10 Page 11
Image 11
Page 10 Page 11
Contents Application Guide Kenwood Radio Table of Contents TK-x80 Model Cable Assembly TK-x150/180 Model Cable Assembly2 IP223 Rev a to Rev E Board Modifications TK-x90 Model Cable Assembly1 IP223 Rev F or higher Board Configuration IP-223 to Kenwood Radios 2 IP223 Jumper settings IP223 ConfigurationPer-line setup screen TK-x80 Series Radio ConfigurationTK-x90 Series Program Function Port, Output screen for COR in Radio 1 AO1 TK-x150/180 Series Technical Support
Top Page Image Contents