Telex 80 manual IP223 Configuration, Per-line setup screen, 2 IP223 Jumper settings

Page 6

4	IP-223 to Kenwood Radios

2.4 IP223 Configuration:

Setup the desired IP223 line for Kenwood radio control at the following screen:

2.4.1 Per-line setup screen

A

B

C

Choose radio model in the Serial Port Mode box (A). Change Serial Port Parameter box to 9600.N.8.2 (B).

Configure Talk Group and CHAN fields for channel change capability (C ).

2.4.2 IP223 Jumper settings

Line 1	Jumper setting	Line 2
J33, J34	“B”=4-wire	J5,	J6
J16, J21	“A”=Single ended	J19,	J20
J14	“A”= 600	J24
J3, J9, J11	“A”=Single ended	J25, J28, J29
J13	“B” High	J27
J17, J22	“B”= 600 ohms	J10,	J15

Image 6

Contents Application Guide Kenwood Radio Table of Contents TK-x150/180 Model Cable Assembly TK-x80 Model Cable AssemblyTK-x90 Model Cable Assembly 1 IP223 Rev F or higher Board Configuration2 IP223 Rev a to Rev E Board Modifications IP-223 to Kenwood Radios IP223 Configuration Per-line setup screen2 IP223 Jumper settings Radio Configuration TK-x80 SeriesTK-x90 Series Program Function Port, Output screen for COR in Radio 1 AO1 TK-x150/180 Series Technical Support