DEALER
EUROPEAN SNAPPER LT SERIES TRACTORS
INTRODUCTION: Snapper LT (One Piece Frame) Tractors are shipped with the steering wheel and seat cushions removed. The following steps are required for
NOTE: Figure 1 shows the seat assembled to the seat pedestal assembly. Some models are shipped with the seat loose and will require installation.
SEAT
SEAT KNOB
SEAT/PEDESTAL
ASSEMBLY
BATTERY
FIGURE 1
ACTIVATE BATTERY
The battery is not installed and is shipped dry. Allow sufficient time for charging and installing the battery before operating the tractor. Pay close attention to the precautionary statements on the battery and in these instructions. Electrolyte must be purchased separately from your local dealer or retailer. You will also need an automotive type battery charger to activate the battery for use.
STEP 1: SEAT/PEDESTAL ASEMBLY REMOVAL
1.Remove the seat/pedestal assembly by removing the two seat knobs that secure it to rear fender. See Figure 1.
Note: The seat switch wires are still connected, so be careful.
2.Move the seat/pedestal assembly forward and out of the way.
WARNING
The electrolyte (acid) produces a highly explosive gas. Keep all sparks, flame and fire away from area when charging battery or when handling electrolyte or battery. Electrolyte (acid) is a highly corrosive liquid. Wear eye protection. Wash affected areas immediately after having eye or skin contact with electrolyte (acid). Flush with clear water and neutralize with baking soda. DO NOT OVER FILL!
3.Remove battery cell caps. Fill cells as required with electrolyte (purchased separately) to proper level. Fill to 3/16” above cell plates. Filling battery with electrolyte will bring the battery to 80% charged state.
Note: 3/16” above cell plates is the recommended level. DO NOT place anything in battery other than specified electrolyte.
STEP 2: ACTIVATING AND CHARGING BATTERY
1.Remove battery from carton.
2.Place battery in a well ventilated area on a level surface.
(OVER)
INSTRUCTION No. 7-4375 (I.R. 2/15/01)
1