Snapper HWPS26600RV important safety instructions Familiarization, Introduction, Nomenclature

Page 5
Section 1 - FAMILIARIZATION

Section 1 - FAMILIARIZATION

WHEEL

DRIVE

CONTROL

SWIVEL WHEEL

LOCK CONTROL

REAR HEIGHT

ADJUSTMENT

LEVER

DEFLECTOR

BLADE CONTROL

ENGINE SPEED CONTROL

GROUND SPEED CONTROL

FUEL TANK

AIR FILTER

OIL FILTER

SWIVEL WHEEL

LOCK

MOWER DECK

FRONT HEIGHT ADJUSTMENT

FIGURE 1.1

1.1 INTRODUCTION

This manual has been prepared for the operators of the SNAPPER WALK BEHIND MOWERS. Its purpose, aside from recommending operating and routine service requirements, is to promote safety through the use of accepted operating practices. Read, Understand and Follow the “IMPORTANT SAFETY INSTRUCTIONS” on Pages 2 & 3 of this manual and all safety messages on the mower and attachments before operating the mower.

IMPORTANT: This machine is equipped with a blade brake clutch (BBC). The engine can be started and operated without engaging the blade. The blade can be disengaged (stopped) without stopping engine.

1.2 NOMENCLATURE

The nomenclature drawing above, Figure 1.1, shows the essential parts of the SNAPPER WALK BEHIND MOWERS. It is recommended that all operators of the mower become thoroughly familiar with the controls, parts and operation of the mower before operating. Specific details involving the engine are found in the separate engine owner’s manual. Study these manuals before operating and keep both handy for future reference.

5

Image 5
Contents MODEL Safety Instructions & Operator’s Manual forMODEL NUMBER EXPLANATION MANUAL No. 4-6813 REV. 1, 8/25/99PROTECTION FOR CHILDREN IMPORTANT SAFETY INSTRUCTIONSSLOPE OPERATION PREPARATIONOPERATION MAINTENANCE AND STORAGETransmission Poly-V Belt Tension Adjustment TABLE OF CONTENTS10-11 12-181.2 NOMENCLATURE Section 1 - FAMILIARIZATION1.1 INTRODUCTION 2.1 PRE-START CHECK LIST Section 2 - OPERATING INSTRUCTIONSwhile the engine is running DO NOT park machine on slopes2.2.2. BLADE 2.2 STARTING & OPERATION2.2.3. PROPELLING MOWER WHEEL DRIVE 2.3 STOPPING 2.3.1. WHEEL DRIVE2.4 HANDLE HEIGHT ADJUSTMENT 2.7 RECYCLING OPERATION OPTIONAL 2.6 SWIVEL WHEEL LOCK and UNLOCKSection 3 - MAINTENANCE 3.2 SERVICE - AFTER FIRST 5 HOURS Continued From Previous Page NEW BLADE Section 4 - REPAIR & ADJUSTMENTSREMOVE BLADE RETAINING BOLTS TO REMOVE BLADE WEAR LIMIT NOTCH STARTS END VIEW OF BLADE1. Stop engine and allow sufficient time to cool 1. Loosen jam nut from ball joint on transfer rod 2. Remove belt guide for the engine to deck belt 3. Remove holder, O-ring and bearing 4. Install new bearing 4. Slip belt off of belt idler 5. Remove belt from hex shaft pulley 1. Remove spindle cover PROBLEM TROUBLESHOOTINGPROBABLE CAUSE CORRECTIVE ACTIONSERVICE SCHEDULE 3 YEAR LIMITED WARRANTY PRIMARY MAINTENANCE PRIMARY MAINTENANCE PRIMARY MAINTENANCE PRIMARY MAINTENANCE SERVICE NOTES SERVICE NOTES 26” STEEL DECK WALK MOWERS SERIES