Snapper SFH13320KW General Operating Safety, Checks Before Starting, Starting the Engine

Page 9

Operating the Walk Behind Mower

GENERAL OPERATING SAFETY

Before first time operation:

Be sure to read all information in the Safety and Operation sections before attempting to operate this machine.

Become familiar with all of the controls and how to stop the unit.

Drive in an open area without mowing to become accustomed to the unit.

CHECKS BEFORE STARTING

Check that crankcase is filled to full mark on dipstick. See the engine Operator’s Manual for instructions and oil recommendations.

Make sure all nuts, bolts, screws and pins are in place and tight.

Fill the fuel tank with fresh fuel. Refer to engine manual for fuel recommendations.

Make sure fuel shut off valve is in the ON position.

WARNING

Before leaving the operator’s position for any reason, disengage the PTO, stop the engine and remove the key.

To reduce fire hazard, keep the engine and mower free of grass, leaves and excess grease. Do not stop or park machine over dry leaves, grass or combustible materials.

Gasoline is highly flammable and must be handled with care. Never fill the tank when the engine is still hot from recent operation. Do not allow open flame, smoking or matches in the area. Avoid over-filling and wipe up any spills.

WARNING

If you do not understand how a specific control functions, or have not yet thoroughly read the FEATURES & CONTROLS section, do so now.

Do NOT attempt to operate the machine without first becoming familiar with the location and function of ALL controls.

STARTING THE ENGINE

Make sure the PTO switch is disengaged.

Set the engine throttle control to FAST throttle posi- tion. Then fully close the choke by pulling the knob OUT fully.

NOTE: A warm engine may not require choking.

Insert the key into the ignition switch and turn it to RUN.

Grasp recoil handle and pull cord briskly. (You may have to pull several times before engine starts. If engine fails to start within a reasonable number of attempts, discontinue and check engine manual for further instructions.)

NOTE: Be sure recoil cord retracts fully into recoil unit. A slack recoil cord can cause serious personal injury and/or damage to unit.

After the engine starts, gradually open the choke (push knob down fully).

Warm up the engine by running it for at least a minute before engaging the PTO lever/switch or driving the mower.

After warming the engine, ALWAYS operate the unit at FULL THROTTLE when mowing.

In the event of an emergency the engine can be stopped by simply turning the ignition switch to STOP. Use this method only in emergency situations. For normal engine shut down follow the procedure given in STOPPING THE MOWER.

DRIVING THE MOWER

Make sure the PTO switch is disengaged.

Start the engine (see STARTING THE ENGINE).

Set the throttle control to FULL.

Grasp the operator presence / parking brake handles and the handle bar grips at the same time to deacti- vate engine kill system and disengage the parking brake.

With your thumbs, pressing the ground speed control levers forward will move the mower forward. Pulling them back will move the mower backwards. The far- ther the levers are pushed or pulled will result in a faster ground speed.

To slow the mower, gently release your thumb pres- sure on the ground speed control levers.

00

9

Image 9
Contents McDonough, GA 30253 USA Safety Instructions & Operator’s Manual forImportant Safety Instructions Safe Handling of Gasoline Maintenance Table of Contents Control Functions Engine Ignition SwitchMotion Control Levers Throttle ControlCutting Height Adjust Handle PTO Engagement SwitchOperational Safety Checks Operator Presence / Parking Brake HandlesDecal Dash Panel Decal Hot Decal Danger Safety DecalsChecks Before Starting General Operating SafetyStarting the Engine Driving the MowerStopping the Mower Operating on a SlopeMowing Pushing the Mower by HandStarting After Long Term Storage StorageTemporary Storage 30 Days Or Less Long Term Storage Longer Than 30 DaysSee Before Every Spring Check Tire PressureFall Tire PressureFuel Filter Checking / Adding FuelOIL & Filter Change Check / Change AIR Filter Replace Spark PlugGreaseOil LubricationServicing the Mower Blades Installing The BladeTroubleshooting the Mower Troubleshooting Adjustments & ServiceTroubleshooting the Mower Deck Troubleshooting, Adjustment & ServiceTo Adjust the Cutting Range Cutting Height AdjustmentTo Adjust the Cutting Height Deck Height IndicatorDeck Leveling Adjustment 4 PlacementTo Level the Mower Deck Belt Removal and Replacement Mower Deck Drive BeltTransaxle Drive Belt Ground Speed Control Lever Location Adjustment Adjusting the Lever HeightAdjusting the Lever Position Blade Brake Check PTO Clutch AdjustmentHOW and When to WATER, Fertilize & Aerate General InformationTypes of GRASS, Climate and Conditions Inch Tall Grass Requires Incremental CuttingProper Cutting Height Cut Here On First Pass SecondWhat Mowing Patterns to USE When and HOW Often to MOWMowing Methods Proper Broadcast MowingProper Mulching Composting How to start a healthy compost pileTips On Dealing With Clippings Methods actually contribute to a healthy lawnStreaking Solutions for Common Mowing ProblemsStepped Cutting Stepped CuttingUneven Cutting ScalpingStingers Snapper Product Registration Form Year Limited Warranty Safety Instructions & Operator’s Manual for

SFH13320KW specifications

The Snapper SFH13320KW is a versatile and powerful lawn mower designed to meet the needs of homeowners seeking efficiency and reliability. This robust mower is powered by a durable 13.5 HP Briggs and Stratton engine, ensuring that it can handle a variety of mowing tasks with ease. One of the standout features of the SFH13320KW is its 33-inch cut width, which allows for efficient mowing in both large yards and tighter spaces, making it ideal for residential properties of all sizes.

Equipped with a 7-speed transmission, the Snapper SFH13320KW offers exceptional maneuverability and control. Users can effortlessly adjust their speed to match the terrain and type of grass being mowed, ensuring optimal cutting performance. The model’s adjustable cutting height ranges from 1 to 4 inches, allowing for personalized lawn care that caters to different grass types and seasonal variations.

One of the remarkable technologies employed in the Snapper SFH13320KW is its lever-controlled drive system. This system provides homeowners with easy operation and allows for quick starts and stops, enhancing user experience and safety. The mower’s compact design features a tight turning radius, making it easy to navigate around trees and garden beds, resulting in a well-manicured lawn without the hassle of missed patches.

The Snapper SFH13320KW also incorporates a robust steel deck, known for its durability and resilience against rust and corrosion. This ensures that the mower remains in excellent condition even after multiple mowing seasons. Furthermore, the electric start option eliminates the need for manual pulling, simplifying the starting process and making it accessible for users of all ages.

Additional characteristics include large rear wheels that provide superior traction and stability, making it easier to tackle uneven terrain. The mower also features a comfortable seat with an ergonomic design, reducing fatigue during extended mowing sessions.

In conclusion, the Snapper SFH13320KW combines power, efficiency, and user-friendly features, making it an excellent choice for homeowners. With its reliable engine, adjustable controls, and sturdy construction, this mower stands out as a reliable tool for maintaining a beautiful and healthy lawn. Whether you're dealing with a small yard or a larger landscape, the Snapper SFH13320KW is equipped to handle your mowing needs effectively.