Snapper SGV13320KW manual Handle Assembly Installation

Page 9

3 unit assembly (cont.)

HANDLE ASSEMBLY INSTALLATION

Install handle assembly (4:1) to upper portion of engine deck using four 1/2" x 1-1/4" hex bolts and serrated flange nuts (4:3-4). Adjust for comfortable operation, then tighten securely.

Locate wiring harness and route harness down the right side of handle assembly. Attach harness terminals to engine, transmission and blade clutch using the wiring diagram at the back of this manual as a guide. Attach harness to right handle bar with two plastic tie wraps.

Route throttle and choke cables (4:22, 22b – attached to handlebar) down left side of handle assembly. Attach each cable to left side of mower handle using metal cable clip. Also install cable routing clip (4:34) onto engine deck

– see Sheet 4 of Parts list for location.

Connect throttle and choke cables to throttle body on lower front of engine – see Throttle/Choke Cable Adjustment in the Maintenance section of this manual for details.

Also attach the safety instruction display bracket (4:30) to the front of the mower dash with two 5/16-18 x 3/4” hex bolts and serrated flange nuts (4:31-32).

Install "L" shaped end of upper brake rod (4:9), from outside, through brake handle (4:5) and brake lock handle (4:10). Secure with fender washer and bridge pin (4:14-15). Attach adjustable rod fitting end (3:41) on lower end of rod to side idler plate (3:21) using flat washer and bridge pin (3:42-43). Repeat for other side. IMPORTANT: Adjust upper rods for handle comfort and proper drive belt release; also adjust lower brake rods (3:14), by means of 5/16” wing nut (3:20) so that brakes will hold firmly when brake lock handle is engaged.

Attach safety

bracket here

Your mower is now ready to be started and checked for proper operation. Some minor final adjustments may be required; see the Maintenance portion of this manual.

GVTP SM32-R0303.1

Image 9
Contents Walk-Behind Mower This page intentionally blank Preliminaries Safety rules regarding outdoor power equipment Slope Operation Unit assembly Caster AssemblyTransmission Shift Lever Assembly Discharge Deflector AssemblyFuel Tank Assembly Transmission Shift Lever AssemblyHandle Assembly Installation Starting the Engine Before Starting EngineTo Start Engine To Shut Engine Down Mower OperationGeneral Rules to Observe Before During Operation Serious Injury or Death can ResultEngaging the Transmission Engaging the Cutting BladesSteering the Unit Adjusting Cutting HeightLubrication Chart GeneralLubrication Adjustments TroubleshootingAdjust Increase Decrease Check Tension Here Increase Decrease Replacement PartsCut Mower REF # QTY Description Sheet 1 Blade Deck GroupSheet 1 Blade Deck Group Engine & Trans Group REF # QTY Sheet 2 Engine & Trans GroupSheet 2 Engine & Trans Group Cut Mower Sheet 3 Side Idler & Axle Group Sheet 3 Side Idler & Axle Group Cut Mower Sheet 4 Handle Group ALL Specifications Subject to Change Without Notice Cut Mower McDonough, GA 30253 U.S.A