Snapper RT Series manual Troubleshooting, Adjustments, & Service

Page 23

Troubleshooting, Adjustments, & Service

TROUBLESHOOTING

While normal care and regular maintenance will extend the life of your equipment, prolonged or constant use may eventually require that service be performed to allow it to continue operating properly.

The troubleshooting guide below lists the most common problems, their causes and remedies.

See the information on the following pages for instruc- tions on how to perform most of these minor adjustments and service repairs yourself. If you prefer, all of these procedures can be performed for you by your local authorized dealer.

WARNING

To avoid serious injury, perform maintenance on the tractor or mower only when the engine is stopped and the parking brake engaged.

Always remove the ignition key, disconnect the spark plug wire and fasten it away from the plug before beginning the maintenance, to prevent accidental starting of the engine.

TROUBLESHOOTING THE TRACTOR

PROBLEM

CAUSE

REMEDY

Engine will not turn over.

1.

Brake pedal not depressed.

Fully depress brake pedal.

 

2.

PTO (electric clutch) switch

Place in OFF position.

 

 

in ON position.

 

 

3.

Cruise control engaged.

Move lever to Neutral position.

 

4.

Circuit breaker tripped.

Wait one minute for automatic reset.

 

 

 

Replace if defective.

 

5.

Battery terminals require

See Battery Maintenance Section.

 

 

cleaning.

 

 

6.

Battery discharged or dead.

Recharge or replace.

 

7.

Solenoid or starter motor faulty.

See your dealer.

 

8.

Safety interlock switch faulty

See your dealer.

 

9.

Not sitting in seat.

Sit in seat.

 

 

 

 

Engine will turn over,

1.

Engine flooded.

Disengage choke.

but will not start.

2.

Safety interlock switch faulty

See your dealer.

 

3.

Spark plug(s) faulty, fouled

Clean and gap or replace.

 

 

or incorrectly gapped.

See engine manual.

 

4.

Water in fuel.

Drain fuel & refill with fresh fuel. Replace fuel filter.

 

5.

Gas is old or stale.

Drain fuel & refill with fresh fuel. Replace fuel filter.

 

 

 

 

Engine starts hard or runs poorly.

1.

Fuel mixture too rich.

Clean air filter. Check choke adjustment

 

2.

Spark plug(s) faulty, fouled, or

Clean and gap or replace.

 

 

incorrectly gapped.

See engine manual.

 

 

 

 

Engine knocks.

1.

Low oil level.

Check/add oil as required.

 

2.

Using wrong grade oil.

See engine manual.

Excessive oil consumption.

1.

Engine running too hot.

 

2.

Using wrong weight oil.

 

3.

Too much oil in crankcase.

Clean engine fins, blower screen and air cleaner. Clean radiator screen. See engine manual.

Drain excess oil.

Engine exhaust is black.

1.

Dirty air filter.

Replace air filter. See engine manual.

 

2.

Choke closed.

Open choke.

 

 

 

 

Engine runs, but tractor will

1.

Ground speed control pedals

Depress pedals.

not drive.

 

not depressed.

 

 

2.

Transmission release lever

Move into drive position.

 

 

in “push” position.

 

 

3.

Drive belt is broken.

See Drive Belt Replacement.

 

4.

Drive belt slips.

See cause and remedy below.

 

5.

Parking brake is engaged.

Disengage parking brake.

22

Image 23
Contents 18HP Hydro Tractors 16HP Hydro Tractors 20HP Hydro Tractors17HP Hydro Tractors Mower Decks Table of Contents Safety Rules & Information Slope Operation Safety Rules and InformationSafe Handling of Gasoline Safety Rules & InformationService & Maintenance Models Identification NumbersCE Identification TAG Markings North AmericanCE Models Safety DecalsSafety Decals North American Models ALL ModelsOperational Safety Checks Safety IconsControl Functions Features & Controls Catcher Open/Close Lever General Operating SafetyAdding Fuel Mowing Operating the TractorStopping the Tractor & Engine Driving the TractorMulching Plug Optional InstallationParking Brake Function Emptying the CatcherStorage Attaching a TrailerMuffler and surrounding areas may be hot Mower Deck Removal InstallationRemoving the Mower Deck Installing the Mower Deck Catcher Removal InstallationFall Before Every SpringCheck Tire Pressures Regular MaintenanceTransmission Maintenance Battery MaintenanceOil LubricationLubricate Rear Axle Shafts Service Interval Yearly4x4 Wood Block Servicing the Mower BladesCheck Mower Blade Timing SET Mower Belt Tension Safety Interlock System CheckPTO Clutch Adjustment Check Engine MaintenanceTroubleshooting, Adjustments, & Service Troubleshooting the Mower Seat Slide Adjustment Seat AdjustmentHopper Latch Adjustment Pitch AdjustmentNuts Steering Gear AdjustmentBrake Adjustment Adjustment NutBattery Charging Troubleshooting, Adjustment, & ServiceCATCHER-FULL Alarm Adjustment Mower Lift AdjustmentAdjust PTO Clutch Window Adjustment Nut Feeler Gauge PTO Clutch AdjustmentTransmission Release Lever Transmission PurgingLeveling The Mower Mower AdjustmentsCutting Height Adjustment Arbor Drive Belt Replacement PTO Belt ReplacementChassis DimensionsEngine TransmissionTechnical Manuals Replacement PartsMaintenance Items Optional Accessories

RT Series specifications

The Snapper RT Series stands out in the realm of riding lawn mowers, combining cutting-edge technology with user-friendly features to enhance lawn care. Designed for residential use, the RT Series ensures both performance and comfort, making it an ideal choice for homeowners looking for a reliable mowing solution.

One of the key features of the Snapper RT Series is its robust engine options. The mowers in this series typically come equipped with powerful engines that deliver efficient performance. Often, these engines are designed to provide easy starting and smooth operation, allowing users to tackle their mowing tasks with minimal hassle.

The RT Series showcases Snapper's patented HiVac deck technology. This unique deck design is engineered to generate superior airflow, resulting in a cleaner, more precise cut. The enhanced airflow lifts grass for a faster and more uniform mowing experience while efficiently bagging clippings. This not only ensures a well-manicured lawn but also minimizes the need for frequent clean-up.

Comfort is a priority in the Snapper RT Series design. The mowers feature an ergonomic seat and easy-to-reach controls, allowing operators to mow for extended periods without discomfort. The adjustable seat adds to this comfort, accommodating a variety of user heights and preferences.

Another notable aspect of the Snapper RT Series is its ease of maneuverability. With a tight turning radius, these mowers can navigate around obstacles with precision. This feature is particularly beneficial for homeowners with complex landscapes, gardens, or flower beds. The lightweight design, coupled with responsive steering, makes mowing under trees, around flower beds, and along fences effortless.

The Snapper RT Series also incorporates advanced safety features. With automatic brakes, blade engagement systems, and other safety mechanisms, users can be assured of a safer mowing experience. These safety technologies help protect the operator while enhancing the overall mowing process.

Durability is a hallmark of the Snapper RT Series. Built from high-quality materials, these mowers are engineered to withstand the rigors of lawn maintenance. Rust-resistant components and a sturdy frame ensure that the mower can handle tough mowing conditions, providing long-lasting reliability.

In summary, the Snapper RT Series offers a powerful combination of performance, comfort, and advanced technology. Its user-friendly design, ease of maneuverability, and robust safety features make it an exceptional choice for homeowners. Whether tending to a small or large yard, the RT Series delivers an efficient and enjoyable mowing experience.